Programmable Remote Control
Setting the flame
Use this setting when you want a particular flame level. For instance, you want to watch flames burn at their highest level and you don’t mind if the room is too hot.
1.To raise the flame, press and hold the ▲ button until the flame gets to the desired level. Let go.
2.To lower the flame, press and hold the ▼ button until the flame gets to the desired level. Let go.
The flame level will remain just as you set it.
Automatic ON/OFF
You can set your fireplace to come on before you wake up and turn off after you leave and then, turn on again just before you come home and turn off after going to bed.
You can leave it like this for the heating season.
1.Decide what temperature you want your fireplace to be at. Also, decide what time you want your fireplace to turn on and off. Finally, decide what time you want it to come back on and off in the afternoon or evening. For the first few times you set the timer, it’s handy to write these times down.
2.Set the temperature (just as you did in the section Setting the temperature.)
3.Press the TIMER button and hold it until P1 ☼ appears and flashes. Let go. While flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you want your fireplace to turn on in the morning.
4.Press the TIMER button and hold it until P1 ☽ appears and flashes. Let go. While flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you want your fireplace to turn off when you leave.
5.Press the TIMER button and hold it until P2 ☼ appears and flashes. Let go. While flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you want your fireplace will turn on again in the afternoon.
6.Press the TIMER button and hold it until P2 ☽ appears and flashes. Let go. While flashing, push the buttons ▲ (hour) and ▼ (minutes) to set the time at which you want your fireplace to turn off in the evening.
Note: If you want to set your fireplace for only one time on and off, set P2 ☼ and P2 ☽ for the same times as P1 ☽. The remote will record the P1 ☽ off time for both P2 times.
To temporarily override the timer setting, just press AUTO or ▲ and ▼ to go back to manual settings. Press TIMER to go back to your settings.
When your remote control displays BATT, you need to replace the battery with a new 9 volt alkaline
29
