Programmable Remote Control
Your fireplace remote control helps you get the comfort, convenience and aesthetics you want from your gas fireplace. The remote controls your fireplace in different ways.
IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and automatic ON/OFF can only be programmed when the function display is flashing. Be patient when programming as it can take a few seconds to set.
Setting the time
The first thing to do is to set the time.
1.With your thumb, hold down both the AUTO and TIMER buttons until F flashes. Let go.
2.Note the digital clock on the bottom right hand corner. The ▲ button sets the hour; the ▼ button sets the minutes. Set the time.
Note: You must start setting the time while the F is flashing. If it stops flashing, go back to 1.
3.The display shows
4.Let go and wait until the flashing stops. The remote shows the time you set. It also shows the current temperature.
Setting the temperature
Use this setting when you come in and want to enjoy a specific temperature.
1.Push the AUTO button until a number and F flash. Let go.
2.While it is still flashing, push the ▲ and ▼ buttons to the temperature you want. Let go.
Your fireplace will reach that temperature and the remote will check the temperature every five minutes, adjusting the amount of fuel needed to give you a steady, even heat.
28
