Sanyo DSR-3000 Recording Images in the Normal Recording Area, Normal recording, Setting the time

RECORDING IMAGES IN THE NORMAL RECORDING AREA

Normal recording

Images can be recorded in the normal recording area while they are being monitored.

If the time has not been set, the digital video recorder cannot make recordings. Be sure to set the time. (See page 42.)

Monitored images are recorded.

1

MENU

2

REC/STOP

Setting the time

Press the MENU button to display the LANGUAGE/CLOCK SET menu, and set the date and time. After the setting has been made, press the EXIT/OSD button, the date and time appear in the operating display. (See page 42.)

Press the REC/STOP button.

“a” appears in the operating display and the images being monitored are recorded in the normal recording area. Recording onto the hard disk proceeds automatically (default setting) according to the following settings. The settings can be changed between long-period recording and high-quality recording in five steps. (See page 49.)

•Hard disk recording areas: Normal recording area: 80% Alarm recording area: 19% Archive area: 1%

•Picture quality: EN (Enhanced)

•Recording method: Field

•Recording speed: 0.10 seconds (54H)

Note: Playback is possible during recording. When the PLAY/STOP button is pressed during recording, “c” appears in the operating display and images are played back from the point where recording began. (See page 20.)

<MAIN MENU 1>

1.LANGUAGE/CLOCK		SET	->
2.VIDEO INPUT SET			->
3.RECORDING	AREA	SET	->
4.RECORDING	CONDITIONS SET ->

<LANGUAGE/LANGUE/IDIOMA> ENGLISH

<CLOCK SET>

01-01-2001 MON 00:00:00

10-26-01

10:48:38 EN 0.10SEC

10-26-01
11:02:28 EN	0.10SEC

Recording start time

3

REC/STOP

Press and hold the REC/STOP button for 3 seconds or more.

The “a” in the operating display disappears and recording stops.

Note: When the remaining area in the normal recording area drops below the set amount, the FULL indicator on the front panel flashes. If recording continues under these conditions, the recording area becomes full and recording stops. In the RECORDING AREA SET settings, carry out the AREA FULL RESET operation for the normal recording area.

Recording will then be possible from the beginning again. (See page 48.)

POWER FULL ALARM FULL LOC

14 English