SP6625 5 gallon RIDGID 9/16/05 2:25 PM Page 8
Storage Rack Assembly & Mounting (cont.)
2.Locate wall stud and position the stor- age rack so that all four screw holes are over the stud. Level the rack and mark the hole locations. Drill a 1/8 inch diam- eter pilot hole at each location. Attach the storage rack to wall studs using the four screws provided. Make sure all four screws are driven securely into the wall stud.
3.If the desired location does not align with a wall stud or the studs are exposed, a 1/2 inch thick plywood panel wide enough to span at least two studs, must be attached to the studs with the four screws provided. The storage rack may then be attached to the plywood panel with four 1 inch #10 pan or round head wood screws (not provided).
NOTE: Supplied wood screws are intended for mounting to typical wall construction consisting of 5/8 inch drywall or less.
CAUTION: To prevent plywood, Storage Rack, or Wet/Dry Vac from falling, make sure you have selected the proper length of fastener for the secure mounting of stor- age rack to the wall.
Storage Rack Screw (4)
8