RIDGID WD55000 owner manual Float/Cage Replacement, Filter Cage Assembly

SP6625 5 gallon RIDGID 9/16/05 2:25 PM Page 6

Float/Cage Replacement

WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete and you have read and understood the safety and operation instructions. Do not operate vac with any parts damaged or missing.

1.Carefully slide the filter over the filter cage, sliding it over the center ring cov- ering the 3 slots until the filter stops against the lid.

2.Place the hole in the filter plate over threaded stud of the filter cage.

3.Gently push on the filter plate to seat the rubber ring of the filter inside the circular channel of the filter plate.

4.Place filter nut onto threaded stud and tighten it down. Finger tighten only.

NOTE: Lever of filter nut should be away from plate as shown.

IMPORTANT: Do not overtighten as this may deform or crack the filter plate, filter cage, or filter.

Filter Nut	Filter Nut
Lever	Filter Plate
	Filter
	Threaded Stud
	Filter Cage
	Slots (3)

WARNING: To avoid personal injury or damage to vac be sure to keep hands, fingers, or any other foreign objects out of the center opening when assembling the float.

Filter Cage Assembly

NOTE: If filter cage or float needs to be removed, or replaced, use a flat blade screwdriver and insert the blade near one of the tabs between the filter cage and the center opening of the lid. Pry the tab out of the slot. Tilt the cage and lift away from the lid. Replace in the following manner:

1.Place the float over the opening in the center of the lid with the words "This Side Towards Lid" laying face down over the hole.

2.Line up filter cage tabs with slots in the center opening of the lid.

3.Push on the filter cage until the tabs snap into slots for a secure fit.

Filter Cage

Tabs (3)

Float	Vac
Solid End

Assembly

THIS SIDE

TOWARD LID

Center

Opening

Slots (3)

Filter Cage

Tabs (3)

Slots (3)

6