Nighthawk KN-COEG-3 manual Part Two Carbon Monoxide and Gas

Page 13

Part Two – Carbon Monoxide and Gas

What is Carbon Monoxide?

Carbon monoxide (CO) is an odorless, colorless, poisonous Gas cre- ated when any fuel is burned – Gasoline, propane, natural Gas, oil, wood, coal, and even tobacco. When combustion air is limited, more CO is produced. Serious problems can develop when combustion by-products are not properly vented outside the house.

You’ve probably heard about carbon monoxide poisoning in the news recently. It’s a problem receiving more attention because groups like the American Lung Association and the Consumer Product Safety Commission have made it a priority to warn the pub- lic about the dangers of this deadly household poison.

What is Natural Gas?

Natural Gas is typically supplied through a main utility line connect- ed to your home. If you do not live in a rural area you are likely to be a user of natural Gas. It is the dominant energy used for home heating with about 55 percent of American homes using Gas. Natural Gas is a fossil fuel comprised almost entirely of Methane. Methane is much lighter than air and will rise rapidly in air. If you are a user of natural Gas, we recommend you mount your Nighthawk unit 12 inches away from the ceiling (using retractable cord feature) to ensure the earliest opportunity to detect a leak.

What is Propane?

Propane is typically supplied to homes via delivery truck in liquid form and stored near the home in propane tanks. Propane is used by homes in rural areas that do not have natural Gas service. Since propane is the most commonly used liquefied petroleum Gas (LPG), “propane” and LP-Gas are often used synonymously. Unlike natural Gas, propane is much heavier than air and will collect at lower lev- els. If you are a user of propane, we recommend you mount your Nighthawk near the floor (using the direct plug-in feature) to ensure the earliest opportunity to detect a leak.

What are the Effects of CO Exposure?

When you breathe carbon monoxide, it enters your bloodstream through your lungs and attaches to red blood cells. These red blood cells, called hemoglobin, carry oxygen throughout your body. Carbon monoxide molecules attach to the red blood cells 200 times faster than oxygen, preventing the flow of oxygen to your heart, brain and vital organs. As carbon monoxide accumulates in your bloodstream, your body becomes starved for oxygen. The amount of carbon monoxide in a person’s body can be measured by a sim- ple blood test, called a “carboxyhemoglobin level” test .

The early symptoms of carbon monoxide poisoning are often mis- taken for the flu – headache, dizziness, weakness, nausea, vomiting, sleepiness, and confusion.

Breathing very high concentrations of carbon monoxide can be lethal in minutes. Breathing low concentrations over time is dangerous, too.

Long term exposure to low levels could cause permanent heart and brain damage.

Could Your Family be at Risk for CO Poisoning? Carbon monoxide is the number one cause of poisoning deaths in the United States. According to the Mayo Clinic, at least 10,000 Americans are affected by CO poisoning each year.

While anyone is susceptible, experts agree that unborn babies, small children, senior citizens and people with heart or respiratory prob- lems are especially vulnerable to CO and are at the

greatest risk for death or serious injury.

Where Does CO Come From?

Inside your home, appliances used for heating and cooking are the most likely sources of carbon monoxide. Vehicles running in attached garages can also produce dangerous levels of carbon monoxide.

A by-product of combustion, carbon monoxide can be a potential problem from a number of common sources – automobiles, furnaces, water heaters, fireplaces, wood stoves, charcoal grills, Gas ranges, space heaters and portable generators.

When these appliances are in good working condition with

proper ventilation, lethal carbon monoxide Gas is vented outdoors where it quickly disperses. But even the slightest malfunction or mis- use of any of these sources can lead to a build-up of carbon monox- ide in your home that can become deadly before you’d even know it’s there.

And you don’t have to have ancient appliances to have a problem. Today’s more energy-efficient, airtight home designs can trap CO-pol- luted air inside where it can quickly build to lethal levels.

What Can You do to Protect Your Family?

To be safe, know the possible sources of CO in your home. Keep fuel-burning appliances and their chimneys and vents in good work- ing condition. Learn the early symptoms of exposure, and if you sus- pect carbon monoxide poisoning, move outside to fresh air and get emergency help. A blood test can confirm that CO caused the prob- lem.

Your first line of defense is an annual inspection and regular mainte- nance of your appliances. Contact a licensed contractor or call your local utility company for assistance.

But remember, problems can begin after an inspection is over, like a crack in a furnace heat exchanger, or a leak in a water heater vent or a bird’s nest blocking a flue. Other sources are nearly impossible to detect: even a change in the air pressure

outside can turn a normally safe situation deadly. That’s why you need the 24-hour protection provided by a CO and Gas alarm.

2-1

Image 13
Contents Carbon Monoxide and Explosive Gas Alarm Table of Contents Introduction About this User’s GuideQuick Set-Up Guide Setting up your CO and Gas alarm for first time operationAbout Your CO and Gas Alarm Part One Your Nighthawk CO and Gas AlarmDigital Display Nighthawk’s Unique FeaturesWhere Not to Install Your CO and Gas Alarm Where to Install Your CO and Gas AlarmDirect Plug Alarm How to Install Your AlarmTo install To rotate adapterNormal Operating Characteristics Wall Mounted AlarmTable Top Alarm Testing the Electronics How to Test Your AlarmTesting the sensor response Malfunction Signal Group 1 Component Failure If the alarm malfunctionsLow Battery Warning Malfunction Signal Group 2 Microprocessor FailureHow to Care for Your Alarm How to Know If Your Alarm is MalfunctioningTo Reset the Peak Level Memory… Peak Level Memory ButtonPart Two Carbon Monoxide and Gas What You Should Not Do Home Safety Tips What You Can DoClues You Cannot See Mid Levels Part Three What You Should Know Before the Alarm SoundsHigh Levels Common Medium Exposure Symptoms Common Mild Exposure SymptomsCommon Extreme Exposure Symptoms What to do if the Alarm Sounds for Gas Part Four What to Do if the Alarm Sounds for GasDo not activate any electrical switch or telephone Treatment for CO PoisoningPart Five Technical Information What happens if the power goes out? Part Six Frequently Asked QuestionsPart Six Frequently Asked Questions Part Six Display Reading and What They Mean Display Shows Alarm Sound Unit StatusDisplay Shows Alarm Sound Unit Status Recommended Action Readings You May See When Unit is AC PoweredPage Wall Mount Diagram Warranty Registration Limited WarrantyPlease send products and all other correspondence to

KN-COEG-3 specifications

The Nighthawk KN-COEG-3 is a state-of-the-art carbon monoxide and explosive gas detector designed to offer paramount safety for homes and workplaces. With its sleek design and advanced technology, this device stands out in the market for its reliability and ease of use. One of the most striking features of the KN-COEG-3 is its dual-function capability, allowing it to detect both carbon monoxide (CO) emitted from sources like gas appliances and vehicles and explosive gases such as natural gas and propane. This dual detection provides an added layer of safety, ensuring that you are alerted to potential dangers in real time.

The device is equipped with a highly sensitive electrochemical sensor for carbon monoxide detection, which offers precise readings and minimizes false alarms. The explosive gas sensor utilizes a catalytic bead technology, which allows for quick identification of dangerous gas leaks. Together, these technologies ensure that you are protected from two of the most serious gas-related hazards.

Another key feature of the Nighthawk KN-COEG-3 is its user-friendly interface. The device includes a well-designed LCD display that provides clear, easy-to-read information regarding the levels of carbon monoxide and explosive gases detected in the air. It also features a loud alarm system that activates immediately upon detection of dangerous levels, ensuring that occupants can promptly respond to evacuation protocols.

The KN-COEG-3 boasts a compact and stylish design, making it easy to install in various locations, whether mounted on a wall or placed on a countertop. It is powered by an AC adapter with a battery backup, which guarantees continuous operation even in the event of a power outage. This reliability ensures peace of mind for users, whether they are at home or away.

Additionally, the device incorporates advanced self-test features that allow it to periodically check its sensor and system functionality, assuring users of its operational integrity. By coupling advanced technology with a commitment to user safety, the Nighthawk KN-COEG-3 presents a compelling solution for anyone looking to enhance their safety against carbon monoxide and explosive gas hazards in their environment.