Crown Boiler MWC116ENT, MWC Series, MWC116ENL, MWC116ELL manual For Your Safety Read Before Operating

MWC Series Lighting and Operating Instructions

FOR YOUR SAFETY READ BEFORE OPERATING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

AThis appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

BBEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

---Do not try to light any appliance.

---Do not touch any electric switch; do not use any phone in your building.

---Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

---If you cannot reach your gas supplier, call the fire department.

CUse only your hand to push in or turn the gas control knob.

Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician.

Force or attempted repair may result in a fire or explosion.

DDo not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above on this label.

2.Turn off all electric power to the appliance.

3.Set the thermostat to lowest setting.

4.This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

5.Close main gas shut off valve.

6.Wait five (5) minutes to clear out any gas. Then smell for gas including near the floor. If you smell gas STOP! Follow “B” in the safety information above on this label.

If you don’t smell gas, go to next step.

7.Open the main gas shut off valve and the valve on the domestic cold water inlet pipe.

8.Turn on the electricity supply to the boiler, switching on the circuit breaker. The appliance

operation light 1 (figure 1) will flash every 4 seconds (stand---by condition).

9.If the boiler is to be used for c.h and d.h.w position the function selector 2 as in figure 2. The appliance operation light 1 will flash every 2 seconds (operating boiler).

Position the knobs 2 and 3 for the desired c.h. and d.h.w. temperature (for detailed information see the user manual).

10.If the boiler is to be used for d.h.w. only position the function selector 2 as in figure 3. The appliance operation light 1 will flash every 2 seconds (operating boiler).

Position the knob 3 for the desired d.h.w. temperature (for detailed information see the user manual).

11.If the appliance will not operate, follow the instructions “To turn off gas to appliance” and call your service technician or gas supplier.

1	2	1	3 (Combi Only) 2	1	3 (Combi Only)	2
	Figure 1		Figure 2		Figure 3

TO TURN OFF GAS TO APPLIANCE

1.Turn off all electric power to the appliance if service is to be performed.

2.Turn the boiler off by setting the function selector 2 to the position shown in figure 1.

3.Set the thermostat or other operating control to lowest setting

4.Close the main gas gas shut off valve and the valve on the domestic cold water inlet

pipe.

56