Desa CGD3924NR installation manual Installing Logs, Installing Back Log #1

Page 18

18

INSTALLING

Continued

INSTALLING LOGS

WARNING

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 15).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 16). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 17).

4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the cross- over log lines up with rectangular knobs on top of the middle and front logs (see Figure 18).

 

Back Log (#1)

Middle Log (#2)

Peg

 

 

 

Hole in

 

Tab

 

Grate Base

 

 

 

 

 

 

Burner

 

 

 

 

Cutout

 

 

 

“U” Bend

 

 

 

U-Shaped

 

 

 

Slot

Figure 15 - Installing Back Log (#1)

Figure 16 - Installing Middle Log (#2)

Front Log (#3)

Notches

Crossover

 

 

 

Log (#1)

Recess

Post

 

Post

Rectangular

Knobs

Figure 17 - Installing Front Log (#3)

Figure 18 - Installing Crossover

 

Log (#4)

103343

Image 18
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety Information Information Operation Local Codes Unpacking Product FeaturesSafety Pilot Piezo Ignition SystemAIR for VentilationProviding Adequate Ventilation AIR for Combustion and Ventilation Determining AIR Flow for Heater LocationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRTion and ventilation air by one of the methods described Ventilation Air From OutdoorsInstalling Check GAS TypeMinimum Fireplace Clearance LOG Sizing RequirementsMinimum Wall and Ceiling Clearances see Figure Minimum Non Combustible Material Clearances Installing Minimum Non Combustible Material Clearances Log SetMinimum Mantel Clearances When Using Hood Installing Heater Base Assembly Installation Items NeededAttaching Flexible Gas Hose to Heater Connecting to GAS Supply Checking GAS Connections Gas ConnectionInstalling Test Pressures Equal To or Less Than 1/2 PsigInstalling Logs Installing Back Log #1Operating HeaterOperating Heater Control Knob and Ignitor Button LocationOperating Inspecting Burners Has been selectedTrouble Shooting CleaningMaintenance ODS/PILOT and BurnerMaintenance, TROUBLE- ShootingCleaning and Mainte TroubleGas leak. See Warning Technical Service Service HintsWiring Diagram Parts Under Warranty Parts Not Under WarrantyParts Central Hood GA6050 AccessoriesValve GA5010 Hood GA6052Illustrated Parts Breakdown CGD3924NR Parts List KEY Part Number Description QTYWarranty Information Keep this Warranty