Desa CGD3924NR installation manual Installing, Check GAS Type

Page 8

INSTALLING

8

NOTICE

A qualified service person must install heater. Follow all local codes.

NOTICE

State or local codes may only allow operation of this appliance in a vented configuration. Check your state or local codes.

WARNING

Make sure the remote selector switch is in the OFF position before installing heater.

WARNING

Before installing in a solid fuel burning fireplace, the chimney flue and firebox must be cleaned of soot, creosote, ashes and loose paint by a qualified chimney cleaner. Creosote will ignite if highly heated. Inspect chimney flue for damage. If damaged, operate heater with flue damper closed.

WARNING

Seal any fresh air vents or ash clean-out doors located on floor or wall of fireplace. If not, drafting may cause pilot outage or sooting. Use a heat-resistant sealant. Do not seal chimney flue damper.

WARNING

Never install the heater

•in a bedroom or bathroom

•in a recreational vehicle

•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater

•in high traffic areas

•in windy or drafty areas

CAUTION

This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.

IMPORTANT: Vent-free heaters add moisture to the air. Although this is benefi- cial, installing heater in rooms without enough ventilation air may cause mildew to form from too much moisture. See Air for Combustion and Ventilation, pages 5 through 7.

CHECK GAS TYPE

Use only natural gas. If your gas supply is not natural gas, do not install heater. Call dealer where you bought heater for proper type heater.

103343

Page 7 Page 9
Image 8
Page 7 Page 9
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety Information Information Local Codes Unpacking Product Features Safety PilotOperation Piezo Ignition SystemProviding Adequate Ventilation AIR forVentilation Determining if You Have a Confined or Unconfined Space AIR for Combustion and VentilationDetermining AIR Flow for Heater Location Ventilation AIR Tion and ventilation air by one of the methods describedVentilation Air From Inside Building Ventilation Air From OutdoorsInstalling Check GAS TypeMinimum Wall and Ceiling Clearances see Figure Minimum Fireplace ClearanceLOG Sizing Requirements Minimum Non Combustible Material Clearances Installing Minimum Non Combustible Material Clearances Log SetMinimum Mantel Clearances When Using Hood Installing Heater Base Assembly Installation Items NeededAttaching Flexible Gas Hose to Heater Connecting to GAS Supply Checking GAS Connections Gas ConnectionInstalling Test Pressures Equal To or Less Than 1/2 PsigInstalling Logs Installing Back Log #1Operating HeaterOperating Heater Control Knob and Ignitor Button LocationOperating Inspecting Burners Has been selectedCleaning MaintenanceTrouble Shooting ODS/PILOT and BurnerMaintenance, TROUBLE- ShootingCleaning and Mainte TroubleGas leak. See Warning Wiring Diagram Technical ServiceService Hints Parts Central Parts Under WarrantyParts Not Under Warranty Accessories Valve GA5010Hood GA6050 Hood GA6052Illustrated Parts Breakdown CGD3924NR Parts List KEY Part Number Description QTYWarranty Information Keep this Warranty
Top Page Image Contents