OPERATING HEATER
Continued
3.Use the STATUS button on the
4.To turn the burners off when operating in the MANUAL mode, press the OFF button. If operating in the auto mode, press the manual button, then press the OFF button The pilot will remain lit.
IMPORTANT: To turn the pilot off, manually turn the control knob on the heater to the OFF position or set remote selector switch to OFF position.
Shows Temperature Setting
|
| HI |
|
| TEMP |
Allows Burners to be Turned |
|
|
On and Off with the Hand- |
|
|
Held Remote Unit. | MAN | LO ON |
The log heater will | AUTO | OFF |
| ||
automatically cycle between |
|
|
pilot and the heat setting that |
| STATUS |
|
| |
has been selected. |
|
|
Increases Room Temperature
Decreases Room Temperature
Turns Burners On and Off
Shows Current Operation Mode
INSPECTING BURNERS
22
Figure 22 - Thermostat Hand-Held Remote Control Unit Selections
Check pilot flame pattern and burner flame patterns often.
PILOT FLAME PATTERN
Figure 23 shows a correct pilot flame pattern. Figure 24 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermocouple. This will cause the thermocouple to cool. When the thermocouple cools, the heater will shut down.
Pilot Burner | Thermocouple | Pilot Burner |
|
| Thermocouple | ||
|
| ||
|
|
|
Figure 24 - Incorrect Pilot Flame
Figure 23 - Correct Pilot Flame Pattern
Pattern
If pilot flame pattern is incorrect, as shown in Figure 24
•turn heater off (see To Turn Off Gas to Appliance, page 21)
•see Troubleshooting, pages 23 through 26
103343