INSTALLING | INSTALLING HEATER TO WALL | |
TO WALL | Mounting Bracket | |
The mounting bracket is located on back panel of heater. It has been taped there for | ||
Continued | ||
shipping. Remove mounting bracket from back panel. |
Mounting
Bracket
Figure 5 - Mounting Bracket Location
Removing Front Panel Of Heater
1.Remove two screws near bottom corners of front panel.
2.Lift straight up on grill guard until it stops. Grill guard will slide up about 1/4".
3.Pull bottom of front panel forward, then down.
4.Remove cardboard packing from grill and glass (VN2000BB) or heat shield (VGN30B).
Figure 6 - Removing Front Panel Of Heater
Methods For Attaching Mounting Bracket To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 16 inches apart from their centers. Attach mounting bracket to wall in one of two ways.
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to wall stud This method provides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to wall anchor This method allows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Continued
100099
11