VFD(R,T,M)30 LOG PLACEMENT (7 LOG SET)
Before you begin: If you are installing logs onto the VFD(R,T,M)30 model, this burner assembly place is supplied with a set of seven ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this burner assembly. Sooting and other problems may result if the logs are not properly and firmly positioned on the burner assembly. Refer to Figure 14 and Figure 15 and corresponding WARNING: when completing following log placement steps.
1.Place front logs (#1, #2, and #3) between grates and main burner. Align notches on front logs with locator tabs in base.
2.Place middle log (#4) between front and rear loop of burner. Note: Do not place on top of pilot assembly.
3.Place rear log (#5) on rear log shelf. Bottom flange is to be placed between the log shelf and burner tube.
4.Place front twig (#6) onto flat areas of middle log (#4) and bottom end of front twig to the back side of the grate tang (4th one from the left).
5.Place the rear twig (#7) onto flat area of rear log (#5) and over the front of the front twig.
Ember Material Placement on Burner
6.After all logs are properly positioned, place small "dime" size pieces of Rockwool lightly across the front burner tube ports. Place the ember material (Rockwool pieces) side by side. Do not stack more than one layer of embers across the burner ports. No more than (1) one packet of ember material (part number 15999) evenly placed on the burner, is recommended on VFDR30 models. See Figure 15.
Description | Part # |
VFD(R,T,M)18 Embers | 15998 |
VFD(R,T,M)24 Embers | 15998 |
VFD(R,T,M)30 Embers | 15999 |
Platinum Bright Embers |
Note: A single layer of embers is to be used when applying Platinum Bright Embers (alone or in combination with stndard embers) to the burner.
6 | 5 | 7 |
| ||
|
|
4
3
12
Figure 14
Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.
Attention: Do not use Figure 14 or Figure 15 to order logs. Refer to Parts Lists and Parts Views to order logs and/or ember material.
EMBER MATERIAL PLACEMENT (SHADED AREA ONLY)
Figure 15
Page 14 |