Heat & Glo LifeStyle 704-902 owner manual Installing Roof Flashing and Vertical Ter- mination Cap

D. Installing Roof Flashing and Vertical Ter- mination Cap

To install roof flashing see Figure 8.13.

For installation of vertical termination cap see minimum vent heights for various pitched roofs (see Figure 8.15).

		HORIZONTAL
		OVERHANG
2 FT.	20 INCHES MIN.	VERTICAL
MIN.
		WALL
	LOWEST
	DISCHARGE
	OPENING
GAS DIRECT VENT
TERMINATION CAP
		X
		12
		ROOF PITCH
		IS X/ 12
	H (MIN.) - MINIMUM HEIGHT FROM ROOF
	TO LOWEST DISCHARGE OPENING
Roof Pitch		H (Min.) Ft.
Flat to 6/12.......................................1.0*
Over 6/12 to 7/12...........................1.25*
Over 7/12 to 8/12.............................1.5*
Over 8/12 to 9/12.............................2.0*
Over 9/12 to 10/12............................ 2.5
Over 10/12 to 11/12 ........................ 3.25
Over 11/12 to 12/12 .......................... 4.0
Over 12/12 to 14/12.......................... 5.0
Over 14/12 to 16/12.......................... 6.0
Over 16/12 to 18/12.......................... 7.0
Over 18/12 to 20/12.......................... 7.5
Over 20/12 to 21/12.......................... 8.0
* 3 foot minimum in snow regions
Figure 8.13 Minimum Height from Roof to Lowest
Discharge Opening

WARNING

Fire Risk.

Explosion Risk.

Inspect external vent cap regularly.

•Ensure no debris blocks cap.

•Combustible materials blocking cap may ignite.

•Restricted air flow affects burner operation.

Caulk the gap between the roof flashing and the outside diameter of the pipe. Also caulk the perimeter of flashing that contacts roof surface as shown in Figure 8.15.

To attach the vertical termination cap, slide the inner col- lar of the cap into the inner flue of the pipe section and place the outer collar of the cap over the outer flue of the pipe section.

Secure with three screws into the outer flue. Secure the cap by driving the three self-tapping screws (supplied) through the pilot holes in the outer collar of the cap into the outer flue of the pipe (see Figure 8.14).

TERMINATION CAP

(1 of 3)

STORM

COLLAR

SCREWS

CAULK

Figure 8.14

CAULK

Figure 8.15

Heat & Glo • Bravo • 704-902 Rev. E • 7/08 25