Niles Audio ZR-8630AVZR-8630AV manual Installation Settings, ALL ON/PAGE DIP Switch Settings

Page 68

INSTALLATION SETTINGS

ALL ON/PAGE DIP SWITCH SETTINGS

The numbers of the six ALL ON/PAGE switches on the hid- den programming panel of the ZR-8630AV correspond to the unit’s zone numbers. (See Figure 46.)

The switches enable (Up) or disable (Down) the individual zone to respond to ALL ON commands and incoming audio pages.

FIXED/VARIABLE PREAMPLIFIER SWITCH

Zones 4, 5, and 6 include a fixed/variable preamplifier switch (see Figure 47) on the rear panel of the ZR-8630AV. Set the switch for these zones to Variable or Fixed based on the con- figuration of the speakers in the zone. (See Configurations 8, 9, and 10 for more details.)

1 2 3 4 5 6

Down

Figure 46

Figure 47

Up

PROGRAMMING MASTER/SLAVE MODE

The factory default mode of the ZR-8630AV MultiZone Receiver is Master, but you can program it to function as Slave 1 or Slave 2 in expanded systems. (See System Configuration 2.) To change the mode of any unit:

1.Turn the ZR-8630AV OFF.

2.Depress the PROGRAM button.

3.While keeping the PROGRAM button depressed, turn the ZR-8630AV ON.

4.The ZR-8630AV then identifies its version by displaying a Ver #.## message (i.e., Ver 1.01) on the LCD display panel for two seconds.

5.The ZR-8630AV then displays a new mode, either Master, Slave 1, or Slave 2.Which mode it selects depends on the previous setting. If the previous mode was Master, it will display Slave 1. If the previous mode was Slave 1,it will display Slave 2. If the previous mode was Slave 2, it will display Master.

6.Release the PROGRAM button. Now the unit is set to a new mode.

7.Repeat Steps 1 through 6 until the ZR-8630AV is in the desired mode.

INSTALLING ZONE LABELS

Pre-printed zone/room labels included with each ZR-8630AV fit in the Zone Label Slots (see Figure 48) to identify each of the six zones. To install these labels:

1.

Remove the appropriate label for Zone 1 from the pre-

BEDROOM

 

printed sheet.

 

2.

Affix the label in Zone Label Slot #1.

 

3.

Repeat steps 1 and 2 for Zones 2 through 6.

 

Figure 48

60

Page 67 Page 69
Image 68
Page 67 Page 69
Contents ZR-8630AV Table of Contents CongratulationsChoosing a Synchronization Method Table of Contents Programming a Home Theater Remote Control to Operate Introduction Features and Benefits Multi-Zone/Multi-SourceCentral Intelligence Elegant and Intuitive User InterfacesSystem-Wide Operation Paging Input for Telephone Systems12V Control Output Expandable for Larger Multi-Zone SystemsLED Zone ON/OFF Indicator Parts Guide ZR-8630AVLED Zone ON/OFF Indicators Parts Guide R-8 Remote Included Source ButtonsZone OFF Button Zone Mute ButtonVolume Keys Master KeysZone OFF Key Zone Mute KeySystem Configurations Configuration 1 SIX ZonesSource Components Introduction to ZR-8630AV ConfigurationsKeypads, IR Sensors, and Remote Controls Source-Component Automation Flasher OutputsVideo Outputs SpeakersConfiguration 2 Adding Zones Using Multiple ZR-8630AV Units Sharing Source Components with Two ZR-8630AV UnitsCD Changer Home Theater Receiver Shared Source-Component Control Configuration 4 Integrating AN IR-CONTROLLED Home TheaterDistributing Audio and Video Signals IntelliControl MSU Configuration 6 Multiple Master Keypad Modules in a Zone Configuration 7 Multiple Listening Areas in a Zone Configuration 8 External Amplifier in a Zone for More Power Niles SI-245 Niles SI-245 Configuration 11 System Paging and External Telephone System Zone 6 Master Bedroom Infrared Command Compatibility Testing for a Possible IR Command ConflictSolving the IR Command Conflict if Present Component CompatibilitySource Power Synchronization What is SOURCE-POWER SYNCHRONIZATION?Source Components with Separate ON/OFF IR Commands Source Components with Latching PowerVideo Sync SOURCE-POWER SynchronizationChoosing a Synchronization Method Voltage Sync Obtaining Voltage SyncLight Sensing Source and Home Theater Sync StatusSource Components that Require Power Synchronization LED Sync StatusIf Home Theater has sync Source Components that Do Not Require SynchronizationOperational Overview Master KEYS/SOURCE ButtonsMaster Key/Source Button Events Source ButtonEvent EventOFF KEY/BUTTON Master KEY/SOURCE Button OperationSingle-Zone Operation OFF Key Events OFF KEY/BUTTON OperationSingle-Zone OFF System-Wide OFFVolume KEYS/BUTTONS Volume Keys/Buttons OperationMute KEY/BUTTON Mute Key/Button OperationFunction KEYS/BUTTONS Function Keys on the Solo MPre-Programmed Tuner Commands Function Key/Button Operation for the Built-in TunersPreset Buttons FRONT-PANEL Tuner OperationTuner Display Tuner Select ButtonOperating a System with Multiple ZR-8630AV Units Identical Source ComponentsShared Source Components Operation from the Home Theater Zone Operating a System Integrated with a Home TheaterOperation from the Stereo Zones Provided by the ZR-8630AV Paging Indication SYSTEM-BUSY IndicationSOURCE-IN-USE Indication Installation PlacementConnecting Speaker Wire to the Niles NO-STRIP Connector ConnectionsConnecting Accessory Keypads Terminating FOUR-PAIR Twisted CableTwisted Cable Connecting IR SensorsConnecting a Sensor using Four-Pair Telephone Paging SOURCE-COMPONENT Home Theater Connecting AN IR Sensor for Local System Control ZR-8630AV Distributed Equipment LocationZR-8630AV Distributed Equipment Location Programming Software Programming Documentation Installer Programming PanelProgramming Overview Mr. Smith ZR-8630AV Programming WorksheetComponent Sync Power Programming Master KEY LabelComponent Brand ModelFunction Keys/Buttons Programming Sequence ProgrammingProgramming a Learning Remote for Zone Operation Off button to turn off the zonesProgramming Overview Programming Overview Step Tuner Command StepZone AMPProgramming Worksheet Programming Worksheet Programming Worksheet Single Power IR Command Two Separate on and OFF IR Commands Latching PowerSource IR Command Master KEY LabelSource Component Source Component Source Component Installation Settings ALL ON/PAGE DIP Switch SettingsFIXED/VARIABLE Preamplifier Switch Programming MASTER/SLAVE ModeVolume Settings Maximum Turn on and Source Change Volume LevelALL on Volume Level Volume LevelSOURCE-IN-USE Setting Video Sync SelectionProgramming IR Commands System Programming StepsIR Commands LED blinks RED Discrete OFF LED Enter IR Discrete OFF Discrete on Alternate IR Learning Mode Program Editing Steps SOURCE-POWER EditingIR Command Editing Sequence Editing Sequence LED blinksStoring Tuner Presets Erasing Individual IR CommandsProgram Erasing Erasing Individual SequencesZR-8630AV System Accessories Select Eight Master KeysZR-8630AV System Accessories Sync AccessoriesSystem Installation Troubleshooting TroubleshootingTroubleshooting the ZR-8630AV Specifications Tuner SectionAM USA/CANADA GeneralPage Page Niles Audio Corporation

ZR-8630AVZR-8630AV specifications

The Niles Audio ZR-8630AV is a sophisticated multi-room audio distribution system designed to deliver high-quality sound throughout your home. Ideal for both residential and light commercial applications, this system enables seamless integration of audio sources, providing a versatile solution for music lovers and entertainment enthusiasts alike.

One of the standout features of the ZR-8630AV is its ability to support eight zones, each of which can independently control audio playback. This flexibility allows users to customize their listening experience in various rooms, ensuring that everyone can enjoy their preferred music at their desired volume. The system can drive up to 30 watts of power per channel, making it suitable for a wide range of speakers, from low-impedance models to high-efficiency types.

The ZR-8630AV is equipped with advanced technology that enhances its performance. One of the key technologies is the proprietary Niles Intelli-Volume technology, which automatically adjusts volume levels based on the audio source and conditions. This feature ensures consistent sound quality across different zones, providing an optimal listening experience.

This audio distribution system also features a user-friendly, intuitive interface that simplifies operation. The built-in IR receiver allows for remote control from various devices, while the easy-to-navigate menu makes it simple to select sources and adjust settings. Additionally, the ZR-8630AV is compatible with third-party control systems, enhancing its integration capabilities in home automation setups.

Another notable characteristic is the ZR-8630AV's ability to connect multiple audio sources, including CD players, satellite receivers, and streaming services. This connectivity ensures users have endless options for their listening pleasure. It prominently features composite and optical digital inputs, making it versatile regarding the types of sources it can accommodate.

Moreover, the ZR-8630AV incorporates high-quality digital-to-analog converters, ensuring that sound reproduction remains pristine and true to the original recording. This focus on audio fidelity makes it a popular choice for audiophiles who refuse to compromise on sound quality.

In summary, the Niles Audio ZR-8630AV is a powerful multi-room audio distribution system that combines exceptional sound quality, advanced features, and seamless connectivity. Its ability to serve multiple zones in a unified manner, coupled with user-friendly controls and compatibility with various audio sources, positions it as a leading choice for anyone looking to create the perfect audio environment in their home.
Top Page Image Contents