Niles Audio ZR-8630AVZR-8630AV manual Installation, Connections, Placement

Page 46

INSTALLATION

PLACEMENT

Place the ZR-8630AV on a flat, level surface such as a table or shelf, with its weight equally distributed on each of its four feet. Placing the weight of the amplifier on the rear or front panel for even an instant will result in damage to the amplifier's connectors and controls.

Like any high-fidelity component, the ZR-8630AV will last much longer if it has adequate ventilation for proper cooling. When you install the ZR-8630AV in a cabinet, either open the rear of the cabinet to admit fresh air for prop- er cooling (see Figure 28), or install two small “boxer fans” to provide continuous airflow in and out of the cabinet (see Figure 29). Place the ZR-8630AV so it has at least seven inches (18 centimeters) of free air space above it. If the amplifier is on a carpeted surface, place a board under its feet. Do not block the ventilation holes on the top and bottom of the ZR-8630AV.

Boxer Fan (55 CFM/1.6 m 3M) directly centered 7” (18 cm) on top of the ZR-8630AV.

Boxer Fan (55 CFM/1.6 m 3M) directly centered 2” (5 cm) behind the ZR-8630AV.

Make sure that there is a minimum of 7” (18 cm) of free air space above the amplifier and 3” (7.6 cm) on each side for pr oper ventilation.

CAUTION! When using low- impedance speaker loads (less than 8 ohms Nominal) refer to Figure 29 for proper placement.

Allow a minimum of 2” (5 cm) of depth behind unit to accommodate cables and connectors.

If the cabinet rear is not open to fresh air or if you’re using low-impedance loads, install two “boxer fans” to provide continuous air flow into and out of the cabinet.

Figure 28

Figure 29

CONNECTIONS

CONNECTING SPEAKER WIRE TO THE NILES NO-STRIP CONNECTOR

The ZR-8630AV features an award-winning, patented no-strip speaker-wire connector. Follow the steps below to connect the speaker wires to the connector and the connector to the ZR-8630AV.

1.Separate the speaker wire so at least two inches (five centimeters) of each conductor is free.

2.Open the no-strip connector by applying pressure to the red and black levers until you hear an audible “click.”

3.Insert the negative (–) unstripped wire fully into the speaker-wire hole next to the BLACK lever and the positive (+) unstripped wire into the speaker-wire hole next to the RED lever. Squeeze the RED and BLACK levers until you hear an audible “click,” indicating that the connector has locked onto the wire. (See Figure 30-A.)

4.Insert the no-strip connector into the corresponding zoned speaker- output socket on the rear panel of the ZR-8630AV. Push it down until it locks in place. The connector fits the socket in only one position. If the terminal does not insert completely, reverse the connector 180 degrees and re-insert. (See Figure 30-B.)

A

B

 

Figure 30

46

Image 46
Contents ZR-8630AV Table of Contents CongratulationsChoosing a Synchronization Method Table of Contents Programming a Home Theater Remote Control to Operate Introduction Central Intelligence Features and BenefitsMulti-Zone/Multi-Source Elegant and Intuitive User Interfaces12V Control Output System-Wide OperationPaging Input for Telephone Systems Expandable for Larger Multi-Zone SystemsLED Zone ON/OFF Indicator Parts Guide ZR-8630AVLED Zone ON/OFF Indicators Zone OFF Button Parts Guide R-8 Remote IncludedSource Buttons Zone Mute ButtonZone OFF Key Volume KeysMaster Keys Zone Mute KeySystem Configurations Configuration 1 SIX ZonesKeypads, IR Sensors, and Remote Controls Introduction to ZR-8630AV ConfigurationsSource Components Video Outputs Source-Component AutomationFlasher Outputs SpeakersConfiguration 2 Adding Zones Using Multiple ZR-8630AV Units Sharing Source Components with Two ZR-8630AV UnitsCD Changer Home Theater Receiver Distributing Audio and Video Signals Configuration 4 Integrating AN IR-CONTROLLED Home TheaterShared Source-Component Control IntelliControl MSU Configuration 6 Multiple Master Keypad Modules in a Zone Configuration 7 Multiple Listening Areas in a Zone Configuration 8 External Amplifier in a Zone for More Power Niles SI-245 Niles SI-245 Configuration 11 System Paging and External Telephone System Zone 6 Master Bedroom Solving the IR Command Conflict if Present Infrared Command CompatibilityTesting for a Possible IR Command Conflict Component CompatibilitySource Components with Separate ON/OFF IR Commands Source Power SynchronizationWhat is SOURCE-POWER SYNCHRONIZATION? Source Components with Latching PowerChoosing a Synchronization Method SOURCE-POWER SynchronizationVideo Sync Voltage Sync Obtaining Voltage SyncLight Sensing Source and Home Theater Sync StatusIf Home Theater has sync Source Components that Require Power SynchronizationLED Sync Status Source Components that Do Not Require SynchronizationOperational Overview Master KEYS/SOURCE ButtonsEvent Master Key/Source Button EventsSource Button EventSingle-Zone Operation Master KEY/SOURCE Button OperationOFF KEY/BUTTON Single-Zone OFF OFF Key EventsOFF KEY/BUTTON Operation System-Wide OFFVolume KEYS/BUTTONS Volume Keys/Buttons OperationMute KEY/BUTTON Mute Key/Button OperationFunction KEYS/BUTTONS Function Keys on the Solo MPre-Programmed Tuner Commands Function Key/Button Operation for the Built-in TunersTuner Display Preset ButtonsFRONT-PANEL Tuner Operation Tuner Select ButtonShared Source Components Identical Source ComponentsOperating a System with Multiple ZR-8630AV Units Operation from the Stereo Zones Provided by the ZR-8630AV Operating a System Integrated with a Home TheaterOperation from the Home Theater Zone SOURCE-IN-USE Indication SYSTEM-BUSY IndicationPaging Indication Connecting Speaker Wire to the Niles NO-STRIP Connector InstallationPlacement ConnectionsConnecting Accessory Keypads Terminating FOUR-PAIR Twisted CableConnecting a Sensor using Four-Pair Connecting IR SensorsTwisted Cable Telephone Paging SOURCE-COMPONENT Home Theater Connecting AN IR Sensor for Local System Control ZR-8630AV Distributed Equipment LocationZR-8630AV Distributed Equipment Location Programming Overview Installer Programming PanelProgramming Software Programming Documentation Mr. Smith ZR-8630AV Programming WorksheetComponent Brand Component Sync Power ProgrammingMaster KEY Label ModelFunction Keys/Buttons Programming Sequence ProgrammingProgramming a Learning Remote for Zone Operation Off button to turn off the zonesProgramming Overview Programming Overview Zone Step Tuner CommandStep AMPProgramming Worksheet Programming Worksheet Programming Worksheet Source IR Command Single Power IR Command Two Separate on and OFF IR CommandsLatching Power Master KEY LabelSource Component Source Component Source Component FIXED/VARIABLE Preamplifier Switch Installation SettingsALL ON/PAGE DIP Switch Settings Programming MASTER/SLAVE ModeALL on Volume Level Volume SettingsMaximum Turn on and Source Change Volume Level Volume LevelSOURCE-IN-USE Setting Video Sync SelectionProgramming IR Commands System Programming StepsIR Commands LED blinks RED Discrete OFF LED Enter IR Discrete OFF Discrete on Alternate IR Learning Mode IR Command Editing SOURCE-POWER EditingProgram Editing Steps Sequence Editing Sequence LED blinksProgram Erasing Storing Tuner PresetsErasing Individual IR Commands Erasing Individual SequencesZR-8630AV System Accessories Select Eight Master KeysZR-8630AV System Accessories Sync AccessoriesTroubleshooting the ZR-8630AV TroubleshootingSystem Installation Troubleshooting AM USA/CANADA SpecificationsTuner Section GeneralPage Page Niles Audio Corporation

ZR-8630AVZR-8630AV specifications

The Niles Audio ZR-8630AV is a sophisticated multi-room audio distribution system designed to deliver high-quality sound throughout your home. Ideal for both residential and light commercial applications, this system enables seamless integration of audio sources, providing a versatile solution for music lovers and entertainment enthusiasts alike.

One of the standout features of the ZR-8630AV is its ability to support eight zones, each of which can independently control audio playback. This flexibility allows users to customize their listening experience in various rooms, ensuring that everyone can enjoy their preferred music at their desired volume. The system can drive up to 30 watts of power per channel, making it suitable for a wide range of speakers, from low-impedance models to high-efficiency types.

The ZR-8630AV is equipped with advanced technology that enhances its performance. One of the key technologies is the proprietary Niles Intelli-Volume technology, which automatically adjusts volume levels based on the audio source and conditions. This feature ensures consistent sound quality across different zones, providing an optimal listening experience.

This audio distribution system also features a user-friendly, intuitive interface that simplifies operation. The built-in IR receiver allows for remote control from various devices, while the easy-to-navigate menu makes it simple to select sources and adjust settings. Additionally, the ZR-8630AV is compatible with third-party control systems, enhancing its integration capabilities in home automation setups.

Another notable characteristic is the ZR-8630AV's ability to connect multiple audio sources, including CD players, satellite receivers, and streaming services. This connectivity ensures users have endless options for their listening pleasure. It prominently features composite and optical digital inputs, making it versatile regarding the types of sources it can accommodate.

Moreover, the ZR-8630AV incorporates high-quality digital-to-analog converters, ensuring that sound reproduction remains pristine and true to the original recording. This focus on audio fidelity makes it a popular choice for audiophiles who refuse to compromise on sound quality.

In summary, the Niles Audio ZR-8630AV is a powerful multi-room audio distribution system that combines exceptional sound quality, advanced features, and seamless connectivity. Its ability to serve multiple zones in a unified manner, coupled with user-friendly controls and compatibility with various audio sources, positions it as a leading choice for anyone looking to create the perfect audio environment in their home.