Versatile Interface Processor Functions
Figure 9 shows proper handling of an interface processor during installation.
Figure 9 Handling Processor Modules for Installation and Removal (Horizontal Orientation Shown)
H4714
Captive installation screws
To remove a VIP, follow these steps:
Step 1 If you are replacing a failed VIP, disconnect all cables from the VIP ports; however, if you are only moving a VIP to another slot, this step is not necessary.
Step 2 Use a screwdriver to loosen the captive installation screws at both ends of the VIP. (See Figure 8.)
Caution Always use the ejector levers to remove or install the VIP. Failure to do so can cause erroneous system error messages indicating a board failure.
Step 3 Place your thumbs on the ejector levers and simultaneously pull both of the ejectors outward (in the opposite direction from that show in Figure 8c) to release the VIP from the backplane connector.
Step 4 Use the VIP handle to carefully pull the VIP straight out of the slot, keeping your other hand under the carrier to guide it. (See Figure 9.) Keep the VIP parallel to the backplane.
Step 5 Place the removed VIP on an antistatic mat or foam pad, or place it in an antistatic bag if you plan to return it to the factory.
Step 6 If the interface processor slot is to remain empty, install a filler
