Bosch Appliances D720B, D720W manual Keypad

Power Indicator

When the red PWR indicator LED lights steadily, your security system is operating from AC voltage and the standby battery is fully charged. When the PWR indicator is off, AC or battery power is not present. When flashing slowly, a low battery power condition is indicated. When flashing quickly, battery power is missing. If the indicator is off or continues to flash, contact your security company.

Command Mode Indicator

When the [COMMAND] bar is pressed, the red Command mode indicator (CMD) lights steadily to show the system is ready to accept a command. If the command requires that a passcode be entered, the CMD indicator slowly blinks, prompting you to enter your passcode. Once a passcode is entered, the Command mode indicator lights steadily again and remains steadily lit while the system is in the command mode. The indicator goes off when the command is completed (or after 15 seconds of inactivity).

Note:	If all of the keypad’s LEDs are blinking in unison, the system requires
	service.

Exiting the Command Mode

If you decide to exit the Command mode before completing the chosen function, you can exit the command mode at any time by pressing the [A] key. The CMD light goes off, confirming that you have left the command mode.

The Keypad

The keypad has a lighted digital keypad used to enter passcodes and system commands into the security system. As you touch the keys to enter a passcode, the keypad emits a short beep tone to indicate that your entry is accepted.

COMMAND Bar

The [COMMAND] bar is used to perform one- or two-digit COMMAND functions.

Note:	Some systems require a security passcode to be entered after the function keys
	or [COMMAND] bar are pressed. If a passcode is required, the CMD light
	blinks. Enter your passcode when you see this light blinking.

Enter (ENT) Key

When the passcode is completed, press the [ENT] key to activate the passcode. If you do not press the [ENT] key, the passcode is ignored by the security system.

When entering a passcode or command at the keypad, each key must be pressed within 5 seconds of the last key entry. After 5 seconds have expired from the last key entry, the entire entry is cleared and the passcode must be started over.

6