Hearth and Home Technologies Cinch Pipe & Termination Cap System installation instructions

Models:

Cinch Pipe & Termination Cap System

These instructions are replacing VP (for Heatilator) and DV (for Heat-N-Glo) pipe assembly instructions. See the appliance installation instructions for configuration of vent assembly and clearances to pipe.

If you need assistance during installation, contact your local dealer or the Technical Serices Dept., Hearth & Home Technologies Inc., phone 1-800-927-6841 or 1-888-427-3973.

If DVP-AD adapters are used off the top of the appliance, the termination height will be raised by 2-3/4 in. overall height.

CAUTION

Sharp Edges

•Wear protective gloves and safety glasses during installation.

WARNING

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged vent system component.

•Modifi catoin of the vent system.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

Any such action may cause a fire hazard.

WARNING

Do not mix pipe, fittings or joining methods from different manufacturers.

Note: An arrow (￿) found in the text signifi es change in content.