Mitsubishi WD-52631 manual Battery Installation, Sleep Timer, Care, Resetting the Remote Control

Chapter 3. TV Operation 35

Remote Control, continued

1

2 5

3

4

			6
	7		11
	8		12
	9
	10		13
			14
			15
			18
	16		19
	17		20
23	24	25	21
26	27	28
	22

Figure 1. Remote Control Overview

Battery Installation

Figure 2

1.Remove the remote control’s back cover by gently pressing in the tab and lifting off the cover.

2.Load the batteries, making sure the polarities (+) and (-) are correct. For best results, insert the negative (-) end first.

3.Snap the cover back in place.

Sleep Timer

Setting the Sleep Timer

3.Press EXIT or wait five seconds without pressing any buttons for the message to disappear.

4.Press SLEEP to view the time remaining before the sleep timer turns off the TV.

Cancelling the Sleep Timer

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After five seconds of inactivity, the message box will disappear.

1

2

Figure 2. The remote control requires two AA alkaline batteries.

Care

For Best Results from the Remote Control:

•Use only alkaline batteries.

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed to do so.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

•Do not mix old and new batteries.

•Do not heat, take apart, or throw batteries into fire.

Resetting the Remote Control

If the slide switch is set to TV and the TV does not respond properly, do the following to reset the remote control.

1.Press and hold POWER for several seconds until the button blinks twice and goes off.

2.Release the POWER button.

3.Press keys 0 0 9 3 5 and the POWER button will blink twice when you finish entering the code. While entering the code, pause for a moment between each key press to ensure it is recognized.

Low-Battery Indicator

1.Press SLEEP on the remote control.

2.Press SLEEP additional times to increase the time in 30-minute increments up to the maximum of 120 minutes.

If you press a key and the POWER indicator blinks five times, replace the remote control’s batteries.