Programming the Remote Control

Chapter 5. Operating Other Devices with the Remote Control

Method 1: Code Entry

1.Move the slide switch at the top of the remote to the position for the product you want to control. Refer to the table below. Only one of each device type can be controlled in each slide-switch position.

Switch Position	Affected Device

Cable/SAT	Cable Box
	DTV Receiver
	Satellite Receiver

VCR	VCR
	DVR
	Laser Disc Player
	DVD Player/Recorder

DVD	DVD Player/Recorder
	DVR
	Laser Disc Player
	VCR

Audio	A/V Receiver
	Audio Amplifier
	CD Player*

2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.

3.Release the POWER button.

4.Enter the first five-digit code listed for your equipment.

•The POWER button blinks twice when you start to enter the code and then once for each additional keypress.

•The POWER button blinks twice when you finish entering a valid code.

•Move the slide switch to another position if you need to start over or wish to exit programming mode.

5.Point the remote control at the equipment and press POWER. If the product has no power on/off function,

press a different key, such as (Play), (Stop), VOL , or MUTE.

•If the equipment responds, the remote control is properly programmed to operate the equipment.

•If the equipment does not respond, repeat steps 2–4 with the next five-digit code listed for your equipment.

IMPORTANT

You may need to reprogram the remote control after changing the batteries.

6.Once you have found the correct code, write it in the space below for future reference.

Switch Position	Device Type	Code

CABLE/SAT

VCR

DVD

AUDIO

Method 2: Code Search

In this method of programming, you step through the remote control’s internal code library to find the correct code for your A/V product.

1.Move the slide switch at the top of the remote control to the correct position for the product. See the table under “Method 1.”

2.Press and hold POWER on the remote control for several seconds until the button blinks twice and goes off.

3.Press keys 9 9 1

4.Press the number 1, 2, or 3 depending on the slide- switch position and the table below.

Switch Position	Number

Cable/SAT	1

DVD, VCR	2

Audio	3

5.Press CH and POWER repeatedly until the product responds by powering on or off. You can press CH to move backward through the code library if needed.

NOTE: If the product has no power on/off function, check for a response using a different function. Press (Play), (Stop), VOL , or MUTE and then re- peatedly press CH / to check for a response.