Mitsubishi WD-52631 manual Indicators Symptom Remarks, Sound Symptom Remarks

Appendices 99

Appendix D: Troubleshooting, continued

Picture

	Symptom	Remarks
8.	When viewing a stopped VCR, white lines	• Turn off video mute for the VCR.
	are rolling on the screen.	• Begin playing the tape.
		• Change the VCR input to the antenna input.
9.	Screen is black when trying to view digital	The PerfectColor™ color balance has been incorrectly set. Press
	channels or IEEE 1394 device.	VIDEO repeatedly until you see the PerfectColor option and press
		ENTER to open the PerfectColor ™ menu.
10.	DVCR analog/digital problems.	If the tape is currently playing but no picture displays, there may
		be a mismatch of the media with the display. Press INPUT to
		display the Input Selection menu. Press ENTER for the DVCR
		device. If digital is selected, try analog, or if analog is selected, try
		digital.

Indicators

	Symptom	Remarks
1.	Lamp indicator light is a constant red.	Turn the TV off for at least 2 minutes. Turn it back on. If light is
		still red, the lamp has failed. Replace it. See Appendix C for
		lamp replacement information. For questions, call Mitsubishi
		Consumer Relations at 800-332-2119.
2.	Lamp indicator light is a flashing yellow.	Lamp cover door is open or lamp cartridge is not secure. See
		Appendix C for lamp replacement information.
3.	Status indicator light is a steady yellow.	Room temperature has exceeded proper levels. Cool the room.
4.	Status indicator light is a steady/flashing red.	Service is required. Contact your dealer or a Mitsubishi Autho-
		rized Service Center to arrange for a service evaluation. Listings
		of Mitsubishi Authorized Service locations can be obtained from
		our web site, www.mitsubishi-tv.com or by calling 1-800-332-
		2119.

Sound

	Symptom	Remarks
1.	There is no sound even when the	• Check if the MUTE button is on.
	volume is turned up.	• The TV’s “Listen to:” setting may be set to SAP.
		• Check that the TV Speakers setting is On in the Audio/Video menu.
		• If using an IEEE 1394 amplifier, check audio source in Input Selection
		menu.
		• Use the SYSTEM RESET button to perform system reset.
2.	The sound does not match the screen	• The TV’s Listen to: setting may be set to SAP.
	picture.	• If using stereo or A/V receiver speakers, check their input selec-
		tion.
		• If using stereo or A/V receiver, check that AUDIO OUT LEFT/
		RIGHT on TV’s back panel is connected to the A/V receiver.