GE JBP25GR Installation Instructions, Aluminum Wiring Connect length of copper building wire to

INSTALLATION INSTRUCTIONS

STEP 4 (continued)

2.Aluminum Wiring

A. Connect length of copper building wire to

range terminal block.

B. Splice copper wires to aluminum wiring using special connectors designed and U.L. approved for joining copper to aluminum, and follow the connector manufacturer’s recommended procedure closely.

NOTE: Wire used, location and enclosure of splices, etc., must conform to good wiring practice and local codes.

STEP 5

4+IRE SYSTEM

SPECIAL GROUNDING INSTRUCTIONS

WARNING:

Frame grounded to neutral of appliance through a link. If used in a MOBILE HOME or if LOCAL CODES do not permit grounding through the neutral:

1.Disconnect the link from neutral.

2.Use grounding terminal or lead to ground unit in accordance with local codes.

3.Connect neutral terminal or lead to branch circuit in usual manner.

(If the appliance is to be connected by means of a cord set, use 4-conductor cord for this purpose.) ,, ,,

:P8::CT”R’ LJ lul J“

c,

GROUND

4TH GROUNDING LEAD ~ F LUG

STEP 6

ANTI-TIP BRACKET INSTALLATION

AN ANTI-TIP bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the IMPORTANT SAFETY INSTRUCTIONS and the instructions that fit your situation before beginning installation.

WARNING

1.Range must be secured by ANTI-TIP bracket supplied.

2.See instructions to install (supplied with bracket).

3.Unless properly installed, range could be tipped by stepping or sitting on door. Injury might result from spilled hot liquids or from range itself.

Typical installation of Anti-Tip bracket

Attachment to Wall

Bracket

\/\\\l/////\\\\\

STEP 7
LEVELING THE RANGE
The range must be level. Leveling feet are locate
at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rotate the
leveling feet in and out as required to level the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, set
the Cleaning Under the Range section in Care
and Cleaning.) On some models, there are plasti
covers which may be removed for easy
adjustment (just squeeze and pull).
One of the rear leveling feet will engage the
ANTI-TIP bracket (allow for some side to side
adjustment). Allow a minimum clearance of 1/8”
between the range and the leveling foot that is tf
be installed into the ANTI-TIP bracket.
Check the range for proper installation into the
ANTI-TIP bracket (after the range has been
properly installed) by grasping the edges of the
REAR burner holes and carefully attempting to
tilt the range forward.
STEP 8	I
FINAL CHECK
Be sure all switches are in the “off” position
	I
before leaving the range.

28