GE JBP28GR Metal Parts, Glass Surfaces, ift-offOven Door, Oven Lamp Replacement on some models

Metal Parts

Do not use steel wool, abrasives,

ammonia or commercial oven cleaners.

To safely ~]ean surfaces; wash, rinse - J:i -.. ~~~ .; .

and then dry with a soft cloth. &

Glass Surfaces

To clean the outside glass finish, use a glass cleaner. Rinse and polish with a dry cloth. Do not allow the water or cleaner to run down inside openings in the glass while cleaning.

1.ift-off Oven Door

The oven door is removable
	‘————————n==.~————-=——-.
but it is heavy. You may need			r
help removing and replacing		“ i
the door.			~
	vi’T/

To remo~7e the door, open it a

fkw inches to the special “stop” ‘q

●Do not rub or clean the door gasket–the fiberglass material

of the gasket has an extremely low resistance to abrasion.

position that will hold the door

.~~

An intact and well-

open. ~Jrasp firmly on each side *9‘==- and 1 if’t the door straight up and off the hinges.

NOTE: Be careful not to place hands between the spring hinge and the oven frame as the spring hinge c~)LIld snap back and pinch your fingers.

To replace the door, make sure the hinges are in the ‘bout’” position. Position the slots in the bottom of the d(mr w](larely over the hinges. Then lower the door slowly and e~enly over both hinges at the same time.

T() C1.EAN THE DOOR:

( 1)0 not immerse door in water.)

Inside of door:

Q Because the area inside the gasket is cleaned during the self clean cycle, you do not need to clean this by hand. Any soap left on the liner causes additional

stains when the oven is heated.

●The area outside the gasket can be cleaned with a Scouring pad.

fitting oven door
gasket is essential for Inside		Gasket	Outside
energy-efficient oven	Gasket		Gasket

operation and good

baking results. If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

Outside of door:

●Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door.

●Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.

●Do not use oven cleaners, cleansing powders or harsh abrasives on the outside of the door.

Oven Lamp Replacement (on some models)

CALTION: Before replacing your	The oven lamp (bulb) is covered with			DO NOT REMOVE ANY
o}’en lamp bulb, disconnect the	a removable glass cover which is			SCREWS TO REMOVE COVER.
electric power for your range at	held in place with a wire. Remove			● Replace bulb with 40-watt home
the main fuse or circuit breaker	the oven door, if desired, to reach the			appliance bulb.
panel or pull the plug.	cover easily.		//	To replace cover:
Be w-e to let the lamp cover and bulb	To remove:
				● Place it into the groove of the lamp
		~~)~.
cool completely before removing or	s Hold your hand
				receptacle. Pull the wire forward to
replacing them. When in use, light		w
	under the cover		:7	the center of cover until it snaps in
bulbf can become warm enough to	so it doesn’t fall	Qo
				place. When in place, the wire
bre:~k if t(~uched with a moist cloth	when released.			holds the cover firmly. Be certain
or towel When cleaning, avoid	With fingers of the same hand,			the wire is in the depression in the
touchin~ warm lamps with cleaning	firmly push back the wire until it			center of the cover.
cloth$ i f the lamp cover is removed.	clears the cover. Lift off the cover.			c Connect electric power to the range.

	● Do not touch hot bulb with a		25
——,.—..—-	wet cloth.
		——