Drip Pans
Surface Unit
‘Drip Pan
To remove the drip pans for cleaning. the surface units must be removed first. Lift the surface unit about one inch above the drip pan and pull it out. Make sure the surface units are completely cool bejbre touching them. Clean the drip pans with soap and water, plastic scouring pad or in the dishwasher. DO NOT CLEAN IN
Do not lift the surface unit more than one inch. If you do, it may not lie flat on the drip pan when you plug it back in.
Repeated lifting of the surface unit more than one inch above the drip pan can permanently damage the receptacle.
To replace a surface unit:
●Replace the drip pan into the recess in the cooktop. Make sure opening in the pan lines up with
the receptacle.
●Insert the terminals of the surface unit through the opening in the drip pan and into the receptacle.
●Guide the surface unit into place so it rests evenly.
Do not cover the drip pans with aluminum foil. Using aluminum foil so close to the receptacle could cause shock, fire or damage to the range.
Cooktop Surface Lamp (on some models)
When changing a cooktop lamp, do not touch the metal at the ends of the lamp.
‘l’he cook(op li~ht is easily replaced with a fluorescent tube of the ~an;e wattage._ Be~”ore changing the lamp, pLl\] the p]LIg to the range or disconnect the power at the main fuse or circuit breaker panel.
To remove:
●Lift the lamp cover by pulling the bottom edge toward you tind then up.
●Place fingers on top near each end of the lamp.
●RtJll the top of the lamp gently toward the front of the range and ~ently pull
To replace:
●Place fingers on the top near each end of the lamp.
●Press the lamp into the slots until it snaps into place.
●Move lamp cover down and snap into place.
Oven Vent |
| |
The oven is ~ented through an opening under the right | Vent | |
rear surface unit. Never cover the opening with | ||
| ||
aluminum foil or any other material. This would |
| |
prevent the oven vent from working properly. |
|
(continued next page)
23
