Hearth and Home Technologies QV32E (120V) Power Supply Wiring, Hardwired appliances only

Page 7

Hearth & Home Technologies - Colville

1445 North Highway, Colville, WA 99114-2124

F. WIRING

Note: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric Code, CSA C2.1 as appropriate.

All wiring to be done by a qualified electrician. Use appropriate wire to meet local and national codes for rated power consumption.

1. Power Supply Wiring

Note: Optional Accessories Requirements: Wiring for optional accessories should be done now to avoid reconstruction.

CAUTION:

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

a.110/120VAC Wall Outlet Installation

1)The appliance is wired from factory with a polarized plug.

2)For ease of electrical hook up, you may wish to install the appliance near an existing outlet. A 15 amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit trips or fuse blows on a regular basis when the appliance is operated. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.

3)Before plugging appliance into wall outlet, make sure all control switches are in the “OFF” position. To access the controls, lift up on the lower grille panel and rotate it forward.

4)If the power cord is not being used, go to Step 1b below. If the cord does not reach the outlet, a No. 16-AWG minimum wire size extension cord rated for a minimum of 1875 watts may be used.

b.110/120VAC Hardwire Installation (Minimum 14 gauge two conductor wire, non-metallic sheathing with ground.)

1)Turn off circuit breaker.

2)Remove cover plate located on the right side of appliance.

3)Disconnect black (L1) and white (L2) wires between the appliance and plug. Remove the power cord from the cover plate. Remove the electrical knockout and install the cable clamp (not provided) onto the cover plate. Remove the connectors on the wires from the appliance and strip them back ½”.

4)Feed 8” of service wire through cable clamp and secure.

5)Connect black (L1) and white (L2) wires of the appliance to the black and white wires from the service. Connect green (ground) wire from appliance to the ground of the service. See Figure 3.

6)Wall switch wiring (see below) is to be done at this time.

7)Replace the cover plate onto the appliance.

8)Remove the protective cover by cutting the tape located on the outer perimeter and follow Section “H. Final Installation” on setting up the appliance.

c.HT240V Heater Kit and 208/220/240VAC Hardwire Installation (Minimum 14 gauge three conductor wire, non-metallic sheathing with ground.)

1)Turn off circuit breaker.

2)Remove cover plate located on the right side of appliance.

3)For HT240V installation only, disconnect black (L1) and white (L2) wires between the appliance and plug. Remove the power cord (HT240V only) from the cover plate.

4)Remove the electrical knockout and install the cable clamp onto the cover plate. Remove the connectors on the wires from the appliance and strip them back ½”.

5)Feed 8” of service wire through cable clamp (not provided) and secure.

6)Connect black (L1), white (L2) and red (L3) wires of the appliance to the black, white and red wires from the service. Connect green (ground) wire from appliance to the ground of the service. See Figure 4.

7)Wall switch wiring (see below) is to be done at this time.

8)Replace the cover plate onto the appliance.

9)Remove the protective cover by cutting the tape located on the outer perimeter and follow Section “H. Final Installation” on setting up the appliance.

2. Wall Switch Wiring (24VAC)

*Do not connect wires to 120/208/240VAC*

(hardwired appliances only)

a.Turn off circuit breaker.

b.Remove cover plate located on the right side of appliance.

c.Feed 8” of wire for the wall switch through the cable clamp and secure. Low voltage wire can be used for the wall switch connection. It is recommended to only go 10’ from the appliance to the wall switch.

7

VILLAGE COLLECTION ELECTRIC FIREPLACE

09/03 4030-240 Rev F

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Electric Fireplaces Installation & Operating InstructionsImportant Instructions ContentsDescription Voltage Watts Amps Appliance DimensionsListing Approvals Canada CertificationDo not expose appliance to the elements such as rain, etc Location and ClearancesAppliance Locations and Space Requirements ClearancesFraming Non-Cabinet or Chase Installation InstallationPower Supply Wiring WiringHardwired appliances only 110V/120V Wiring Diagram Noncombustible Finishing Material Finishing ChecklistFinishing Combustible Finishing MaterialFinal Installation Install the Andirons Place the Lava Rock Replace the Log AssemblyInstall the Door Front Place the White RockManual Controls Operating InstructionsHand Held Remote Transmitter/Appliance Initialization Hand Held Remote Control Transmitter RCE-QUAD OptionalRemote Transmitter Function FCC RequirementsReplacing the Light Bulbs Maintenance InstructionsCleaning the Firebox and Control Compartment Cleaning the Glass Doors & Back Glass2019 Installing the Heater Heater System MaintenanceIssues Possible Causes Solutions TroubleshootingSurrounds & Trim Optional ComponentsFront Faces CabinetsReplacement Parts Qty Log Set RefractoriesHome Owner’s Notes Index SymbolsHow to Obtain Service Warranty

QV32E (120V), QV32EV, QV32E specifications

Hearth and Home Technologies has established a strong reputation for quality and innovation in the realm of home heating solutions. Their line of electric fireplaces, particularly the QV32EV, QV32E, and QV32E (120V), exemplifies this commitment by blending aesthetic appeal with advanced technology.

The QV32EV stands out due to its versatile design, allowing it to fit seamlessly into a variety of spaces, whether modern or traditional. With its 32-inch screen, it offers a striking focal point that captivates any room. The electric fireplace provides realistic, flame-like visuals, employing LED technology that creates an impressive ambiance without the need for wood or gas. Users can enjoy the warmth and glow of a fireplace without the associated hassle of traditional fuel sources, making it an ideal choice for those seeking convenience and functionality.

The QV32E model is similarly designed to deliver the same exceptional features but comes equipped with enhanced control options. It includes a remote control that allows users to adjust flame brightness, heat settings, and even set a timer, ensuring a customized experience. The model is also designed for easy installation, requiring minimal effort to mount on walls or integrate into existing spaces.

For the QV32E (120V), the convenience of using a standard electrical outlet opens the door for easy placement in any area without the complications of gas lines or venting systems. This model also prioritizes safety, featuring an automatic shut-off system that engages when the unit overheats, providing peace of mind for users.

Each model within this series boasts an adjustable heat output, enabling users to select the level of warmth that best suits their needs. The efficient heating technology not only enhances comfort but also lowers energy costs compared to traditional heating methods.

Additionally, the stylish design, coupled with a range of customizable options, allows consumers to select different logs and media to tailor the appearance of their fireplace according to personal style preferences.

In summary, Hearth and Home Technologies' electric fireplaces—QV32EV, QV32E, and QV32E (120V)—offer a perfect blend of aesthetics, functionality, and user-friendly features, making them an unparalleled choice for anyone looking to enhance their living space. Ideal for all types of interiors, these electric fireplaces represent a modern solution for home heating needs, providing both beauty and efficiency.
Top Page Image Contents