Hearth and Home Technologies QVI-25FB-S owner manual Lighting Appliance, Standing Pilot Ignition

Page 26

B. Lighting Appliance

Standing Pilot Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS

1.Turn off all electric power to the appliance.

2.Push in gas control knob slightly and turn clockwise to “OFF”.

A. This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these in- structions exactly.

B. BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to re- pair it, call a qualified service tech- nician. Force or attempted repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

NOTE: Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in slightly. Do not force.

3.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the Safety Informa- tion located on the left side of this label. If you don’t smell gas, go to next step.

4.Find the pilot. The pilot is inside combustion chamber next to the main burner.

5.Turn knob on gas control counter clockwise

to “PILOT”.

6. Push in control knob all the way and hold in. Im-

mediately depress red or black piezo button. It may

require several depressions of the red or black

piezo button until PILOT lights. If PILOT light does

WARNING: CAUTION:

not light after 10 seconds, return to step 3. Continue to

hold the control knob in for about one minute after the

pilot is lit. Release knob and it will pop back out. Pilot

should remain lit. If it goes out, repeat steps 3 through 6.

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, al- teration, service or maintenance can cause injury or property damage. Re- fer to the owner’s information manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause can- cer, birth defects, or other reproduc- tive harm.

Keep burner and control compartment clean. See installation and operating instructions accompanying appliance.

Hot while in operation. Do not touch. Keep children, clothing, furniture, gaso- line and other liquids having flammable vapors away.

Do not operate the appliance with panel(s) removed, cracked or broken. Replacement of the panel(s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and propane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the alternate fuel.

Also Certified for Installation in a Bedroom or a Bedsitting Room.

For assistance or additional informa- tion, consult a qualified installer, ser- vice agency or the gas supplier.

• If knob does not pop up when released, stop and im-

 

mediately call your service technician or gas supplier.

•

If the pilot will not stay lit after several tries, turn

 

the gas control knob to “OFF” and call your service

 

technician or gas supplier.

7.

Turn gas control knob counterclockwise to

“ON”.

8.To light Burner, flip the on/off switch to the “ON” position, and close access grille.

9.Turn on all electric power to the appliance.

TO TURN OFF GAS TO APPLIANCE

1. Turn off all electric power to the appliance if service is to be performed.

2.

Open control access panel.

3.

Move switch to “OFF” position.

4.

Push in gas control knob slightly and turn clock-

 

wise

to OFF”. Do not force.

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

5.

Close control access panel.

 

464-903G

26

Quadra-Fire • QVI-25FB-S • 2031-910 Rev. E • 9/08

Page 25 Page 27
Image 26
Page 25 Page 27
Contents HOT Surfaces ModelWhat to do if you smell gas Homeowner Reference Information XxxxxxxxTable of Contents Listing and Code Approvals Inspect Appliance and Components Design and Installation ConsiderationsGetting Started Tools and Supplies NeededFireplace Size Requirements Minimum Fireplace OpeningClearances Clearances to Mantels or other Combustibles above ApplianceTermination Locations Vent Termination Minimum ClearancesHorizontal Venting Vent Information and DiagramsVent Table Key Measuring StandardsInstallation Preparation Venting Components Installing Vent Pipe and ApplianceConnecting Vent Pipe Class a Wood Pipe Inlet AIR Vent Pipe Stainless Steel Placing, Securing and Leveling the Appliance Factory Built Wood Burning Installing Adaptor and Termination CapMasonry Damper Flashing Kit OptionalGas Pressures Gas InformationFuel Conversions Gas Connection High Altitude Installations Check for GAS LeaksElectrical Information Wiring the ApplianceON/OFF Switch Appliance RequirementsOptional Accessories Junction Box InstallationInstallation for Fan Optional Fan Wiring Diagram Finishing Mantel ProjectionsAccessories Appliance SetupClean the Appliance Ember PlacementPositioning the Logs Log Set Assembly LOGS-2031Log Placement Quadra-Fire QVI-25FB-S 2031-910 Rev. E 9/08 Removing Glass Assembly Glass AssemblyAir Shutter Setting Replacing Glass AssemblyBefore operating this appliance have a qualified technician Operating InstructionsBefore Lighting Appliance What to do if YOU Smell GAS Lighting ApplianceStanding Pilot Ignition Check Pilot Flame Appearance Initial Break-in ProcedurePilot Adjustment After Appliance is LitFrequently Asked Questions Issue SolutionsStanding Pilot Ignition System TroubleshootingSymptom Possible Causes Corrective Action Troubleshooting Symptom Possible Cause Corrective ActionMaintenance Tasks Maintaining and Servicing ApplianceInspect Maintenance Tasks Doors, SurroundsReference Materials Appliance Dimension DiagramQVI-25FB-S Model Dimensions Vent Kits Components Direct Vent Flex Liner Kits119 1312 Log Set AssemblyService Parts List Part number list on followingAt Depot Service PartsStocked Valve Assembly CONDITIONS, Exclusions & Limitation of Liability Limited Lifetime Warranty Contact Information

QVI-25FB-S specifications

Hearth and Home Technologies has carved a niche for itself in the realm of modern heating solutions, and the QVI-25FB-S fireplace is a testament to their commitment to innovation, efficiency, and aesthetic appeal. This model brings together cutting-edge technologies and design elements that elevate any living space, combining functionality with style.

The QVI-25FB-S is a direct vent gas fireplace insert, which means it can be installed into an existing fireplace or new construction. One of its standout features is its aesthetic versatility, available in multiple finishes and styles to fit seamlessly into various home decors. Its clean, contemporary lines and realistic flame presentation create an inviting ambiance, making it a perfect focal point in any room.

This model excels in energy efficiency, boasting an impressive efficiency rating. It utilizes advanced combustion technology that ensures minimal energy wastage while providing consistent heat output. The direct venting system is designed to draw air from outside, making it a great choice for energy-conscious homeowners looking to reduce their heating bills without sacrificing comfort.

One of the hallmark features of the QVI-25FB-S is its user-friendly interface. Equipped with a simplified remote control, this fireplace enables easy adjustment of flame height and heat output, catering to the user's comfort preferences. This allows for maximum convenience, whether you want to create a cozy atmosphere on a chilly night or provide moderate warmth during cooler seasons.

For safety and reliability, the QVI-25FB-S includes several important safety features. An automatic shut-off system ensures the unit will turn off if it detects any irregularities. Additionally, its glass front comes with a safety screen to prevent accidental contact with the hot surface, making it an ideal choice for homes with children or pets.

The QVI-25FB-S also supports eco-conscious lifestyles. By utilizing natural or propane gas, it produces lower emissions compared to traditional wood-burning fireplaces, making it a cleaner option for heating. The fireplace's innovative design minimizes pollutants while maximizing heat output, aligning perfectly with sustainable living practices.

In conclusion, the Hearth and Home Technologies QVI-25FB-S fireplace insert is a superior choice for those seeking an efficient, stylish, and user-friendly heating solution. With its advanced technology, safety features, and environmental considerations, it is well-suited for today’s modern home, delivering warmth and elegance year-round. Whether you are remodeling or building anew, this fireplace promises to be a stunning and practical addition to your living space.
Top Page Image Contents