Hearth and Home Technologies SL-550TV-D Glass Assembly, Screen Mesh, Grilles and Trim, Hood

TAB LOCATOR

6

LOG #6 (SRV2045-701):Place log #6 so that the right edge fits into the notch on log #5, the middle goes into the tab on log #1, and the left edge rests on log #3.

H. Glass Assembly

WARNING

Handle glass doors with care.

•Inspect the gasket to ensure it is undamaged.

•Inspect the glass for cracks, chips or scratches.

•Any scratch in glass, requires replacement.

•Do NOT strike, slam or scratch glass.

•Do NOT operate appliance with glass door removed, cracked, broken or scratched.

•Replace glass door assembly as a complete appliance.

Removing Glass Assembly

Pull the four glass assembly latches out of the groove on the glass frame. Remove glass door from the appliance (see Figure 12.17).

Replacing Glass Assembly

Replace the glass door on the appliance. Pull out and latch the four glass assembly latches into the groove on the glass frame.

LATCHES

(BOTH BOTTOM

AND TOP)

I. Screen Mesh

The screen mesh is a protective barrier and must be attached.

J. Grilles and Trim

Install optional marble and brass trim surround kits as desired. Marble, brass, brick, tile, or other non-combustible materials can be used to cover up the gap between the sheet rock and the appliance.

Do not obstruct or modify the air inlet/outlet grilles or hood. When overlapping on both sides, leave enough space so that the bottom grille can be lowered and the trim door removed.

K. Hood

Hood is included with the front and required in all installations.

L. Shutter Settings

Models	NG	LP
SL-550TV-D	1/4 in.	3/8 in.
SL-750TV-D	1/4 in.	3/8 in.
SL-950TV-D	3/8 in.	Full open

GLASS

ASSEMBLY

Figure 12.17 Glass Assembly

30 Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. H • 9/06