Hearth and Home Technologies SL-950TV-IPI-D, SL-550TV-D Lighting Appliance, Intellifire Ignition

Page 32

C. Lighting Appliance

Intellifire Ignition

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS

(IPI)

1. Turn off all electric power to the appli-

ance.

A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burner. Do not try to light the burner by hand.

B. BEFORE LIGHTING, smell all

around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas sup- plier, call the fire department.

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

2. This appliance is equipped with an igni-

tion device which automatically lights the

burner. Do not try to light the burner by

hand.

GAS

VALVE

3. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the

floor. If you smell gas, STOP! Follow “B”

in the Safety Information located on the left

side of this label. If you don’t smell gas,

go to next step.

WARNING:

DO NOT CONNECT 110 VAC TO THE CONTROL VALVE.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property dam- age. Refer to the owner’s infor- mation manual provided with this appliance.

This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.

If not installed, operated, and main- tained in accordance with the man- ufacturer’s instructions, this product could expose you to substances in fuel or fuel combustion which are known to the State of California to cause cancer, birth defects, or other reproductive harm.

Keep burner and control compart- ment clean. See installation and operating instructions accompanying appliance.

CAUTION:

Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable vapors away.

Do not operate the appliance with panel(s) removed, cracked or bro- ken. Replacement of the panel(s) should be done by a licensed or qualified service person.

NOT FOR USE

WITH SOLID FUEL

For use with natural gas and pro- pane. A conversion kit, as supplied by the manufacturer, shall be used to convert this appliance to the al- ternate fuel.

Also Certified for Installation in a Bedroom or a Bedsitting Room.

For assistance or additional infor- mation, consult a qualified installer, service agency or the gas supplier.

4.

Turn on all electric power to the appli-

 

ance.

5.

To light the burner, flip the ON/OFF

 

switch to the “ON” position. (The ON/OFF

 

switch may include a wall switch if so

 

equipped).

6.

If the appliance will not operate, follow the

 

instructions “To Turn Off Gas to Appliance”

 

and call your service technician or gas

 

supplier.

TO TURN OFF GAS TO APPLIANCE

1.Turn off all electric power to the appliance if service is to be performed.

2.Flip ON/OFF switch to the “OFF” posi- tion.

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

Final Inspection by _____________________________

593-913D

32

Heat & Glo • SL-550 / 750 / 950TV-D2053-985 Rev. H • 9/06

Image 32
Contents What to do if you smell gas Congratulations Homeowner Reference InformationTable of Contents 1Listing and Code Approvals Glass SpecificationsBTU Specifications ModelsCombustible Materials Specification High Altitude InstallationsNon-Combustible Materials Specification Design and Installation Considerations Getting StartedNegative Pressure Tools and Supplies Needed Inspect Appliance and ComponentsFraming and Clearances Selecting Appliance LocationConstructing the Appliance Chase ClearancesMantel Projections Clearances to Mantels or other Combustibles above ApplianceTermination Locations Vent Termination Minimum ClearancesVent System Configuration Vent Information and DiagramsVent Guidelines Minimum Vertical Feet Vertical Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Gas and Electrical Connections Installing Outside Air Kit Damper AssemblyAppliance Preparation Securing and Leveling Appliance Proper Positioning, Leveling and Securing of aInstalling Vent Pipe Assembly of Vent SectionsSecuring Vent Sections Attaching Vent to FireboxGas Information Fuel Conversions Gas ConnectionGas Pressures Pressure Natural Gas PropaneHigh Altitude Installations Recommendation for Wire Connecting to the ApplianceIntellifire Ignition System Wiring Optional Accessories RequirementsStanding Pilot Ignition System Wiring Ground toJunction Box Installation Wall Switch Installation for Fan OptionalFinishing Facing MaterialAppliance Setup Clean the ApplianceAccessories Remove Shipping MaterialsLog Set Assembly LOGS-SL550-D Models SL-550TV-D Positioning the LogsTAB Locator Log Set Assembly LOGS-SL750-D Models SL-750TV-D, SL-950TV-D Notches Raised Flat Spots Glass Assembly Shutter SettingsScreen Mesh Grilles and TrimOperating Instructions Before Lighting ApplianceCheck Appliance Draft Before operating this appliance have a qualified technicianLighting Appliance Intellifire IgnitionFor Your Safety Read Before Lighting Instructions Standing Pilot IgnitionAfter Appliance is Lit Frequently Asked QuestionsInitial Break-in Procedure Standing Pilot Ignition System TroubleshootingSymptom Possible Causes Corrective Actions Troubleshooting Symptom Possible Cause Corrective ActionIntellifire Ignition System Symptom Possible Causes Corrective Actions Maintaining and Servicing Appliance Before servicingInspect Maintenance Tasks Reference Materials Appliance Dimension DiagramAppliance Dimensions Table Service Parts Log Set AssemblyService Parts List Additional service part numbers may appear on the followingSL-750TV-D SL-750TV-D SL-950TV-D 151SL-950TV-D SL-550 / 750 / 950TV-D-IPI Common Parts Serial # Part Number SL-550 / 750 / 950TV-D 10-06 530-510A Limited Lifetime Warranty Limited Lifetime Warranty Heat & GLO GAS Appliance ProductsContact Information Do not Discard this Manual

SL-950TV-D, SL-750TV-D, SL-550TV-D, SL-550TV-IPI-D, SL-950TV-IPI-D specifications

Hearth and Home Technologies offers an impressive range of gas fireplaces with the SL-750TV-IPI-D, SL-950TV-IPI-D, SL-550TV-IPI-D, SL-550TV-D, and SL-750TV-D models. Each of these fireplaces showcases innovative design, outstanding performance, and advanced technology, making them a perfect choice for any modern home.

The SL-750TV-IPI-D is known for its large viewing area, providing a spectacular flame presentation that is both customizable and efficient. Its advanced IntelliFire® ignition system ensures reliable and easy operation, minimizing the need for manual ignition. This model also offers a balanced flue design that allows for flexible installation options, enhancing its versatility.

Similarly, the SL-950TV-IPI-D boasts a larger firebox, providing even more impressive heat output and increased aesthetics. Its high-efficiency rating ensures that energy consumption is kept low while delivering warmth. This model also utilizes the IntelliFire system, but it is enhanced with LED accent lighting, creating an inviting atmosphere while complementing the fireplace’s flickering flames.

On the smaller end of the spectrum, the SL-550TV-IPI-D combines compact design with remarkable efficiency. Its direct vent technology offers excellent venting options, allowing installation in various locations without compromising on performance. Equipped with adjustable flame settings, homeowners can tailor the experience to their liking, creating the perfect ambiance for any occasion.

The SL-550TV-D model takes a similar approach but focuses on traditional control mechanisms. This version allows users to manage the fireplace with ease through a manual control system while still maintaining the benefits of direct vent technology.

Lastly, the SL-750TV-D version offers a grand fireplace experience. It features a stunning glass front and can serve as a stunning focal point in larger living spaces. The model's durability is paired with elegant aesthetics, ensuring clients receive not just a heating solution but also a piece of art.

Collectively, all five models prioritize efficiency, design, and user-friendly features, ensuring that Hearth and Home Technologies delivers high-performing solutions that meet varied homeowner needs while offering the flexibility of installation and styles that fit seamlessly into any environment. Whether seeking warmth, style, or both, these fireplaces are worthy investments that enhance home living.