Hearth and Home Technologies SL-950TV-IPI-D, SL-550TV-D, SL-750TV-IPI-D Tools and Supplies Needed

Page 8

C. Tools and Supplies Needed

Before beginning the installation be sure that the following tools and building supplies are available.

Reciprocating saw

Framing material

Pliers

Hi temp caulking material

Hammer

Gloves

Phillips screwdriver

Framing square

Flat blade screwdriver

Electric drill and bits (1/4 in.)

Plumb line

Safety glasses

Level

Tape measure

Manometer

Voltmeter

Non-corrosive leak check solution

1/2 - 3/4 inch length, #6 or #8 Self-drilling screws One 1/4 inch female connection (for optional fan).

D. Inspect Appliance and Components

WARNING

Inspect appliance and components for damage. Damaged parts may impair safe operation.

•Do NOT install damaged components.

•Do NOT install incomplete components.

•Do NOT install substitute components.

Report suspected damaged parts to dealer.

The following B-vent components are needed for installa- tion (see Figure 2.2).

•Fireplace Box

•Pipe Components

•Firestops

•Attic Insulation Shield

•Elbows

•Strapping

•Roof Flashing or Chase Top

•Termination Cap

•Storm Collar

•Carefully remove the appliance and components from the packaging.

•The vent system components and trim doors are shipped in separate packages.

•The gas logs may be packaged separately and must be field installed.

•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.

VERTICAL TERMINATION CAP

STORM COLLAR

ROOF FLASHING

OR CHASE TOP

ATTIC INSULATION SHIELD

FIRESTOP SPACER

GAS B-VENT

PIPE SECTION (S)

Figure 2.2 Typical Vertical Installation

•Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure maximum safety and benefit.

WARNING

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance or vent system component.

•Modification of the appliance or vent system.

•Installation other than as instructed by Hearth & Home Technologies.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

Any such action may cause a fire hazard.

8

Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. H • 9/06

Page 7 Page 9
Image 8
Page 7 Page 9
Contents What to do if you smell gas Congratulations Homeowner Reference InformationTable of Contents 1Listing and Code Approvals Glass SpecificationsBTU Specifications ModelsCombustible Materials Specification High Altitude InstallationsNon-Combustible Materials Specification Design and Installation Considerations Getting StartedNegative Pressure Tools and Supplies Needed Inspect Appliance and ComponentsFraming and Clearances Selecting Appliance LocationConstructing the Appliance Chase ClearancesMantel Projections Clearances to Mantels or other Combustibles above ApplianceTermination Locations Vent Termination Minimum ClearancesVent System Configuration Vent Information and DiagramsVent Guidelines Minimum Vertical Feet Vertical Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Gas and Electrical Connections Installing Outside Air Kit Damper AssemblyAppliance Preparation Securing and Leveling Appliance Proper Positioning, Leveling and Securing of aInstalling Vent Pipe Assembly of Vent SectionsSecuring Vent Sections Attaching Vent to FireboxGas Information Fuel Conversions Gas ConnectionGas Pressures Pressure Natural Gas PropaneHigh Altitude Installations Recommendation for Wire Connecting to the ApplianceIntellifire Ignition System Wiring Optional Accessories RequirementsStanding Pilot Ignition System Wiring Ground toJunction Box Installation Wall Switch Installation for Fan OptionalFinishing Facing MaterialAppliance Setup Clean the ApplianceAccessories Remove Shipping MaterialsLog Set Assembly LOGS-SL550-D Models SL-550TV-D Positioning the LogsTAB Locator Log Set Assembly LOGS-SL750-D Models SL-750TV-D, SL-950TV-D Notches Raised Flat Spots Glass Assembly Shutter SettingsScreen Mesh Grilles and TrimOperating Instructions Before Lighting ApplianceCheck Appliance Draft Before operating this appliance have a qualified technicianLighting Appliance Intellifire IgnitionFor Your Safety Read Before Lighting Instructions Standing Pilot IgnitionAfter Appliance is Lit Frequently Asked QuestionsInitial Break-in Procedure Standing Pilot Ignition System TroubleshootingSymptom Possible Causes Corrective Actions Troubleshooting Symptom Possible Cause Corrective ActionIntellifire Ignition System Symptom Possible Causes Corrective Actions Maintaining and Servicing Appliance Before servicingInspect Maintenance Tasks Reference Materials Appliance Dimension DiagramAppliance Dimensions Table Service Parts Log Set AssemblyService Parts List Additional service part numbers may appear on the followingSL-750TV-D SL-750TV-D SL-950TV-D 151SL-950TV-D SL-550 / 750 / 950TV-D-IPI Common Parts Serial # Part Number SL-550 / 750 / 950TV-D 10-06 530-510A Limited Lifetime Warranty Limited Lifetime Warranty Heat & GLO GAS Appliance ProductsContact Information Do not Discard this Manual

SL-950TV-D, SL-750TV-D, SL-550TV-D, SL-550TV-IPI-D, SL-950TV-IPI-D specifications

Hearth and Home Technologies offers an impressive range of gas fireplaces with the SL-750TV-IPI-D, SL-950TV-IPI-D, SL-550TV-IPI-D, SL-550TV-D, and SL-750TV-D models. Each of these fireplaces showcases innovative design, outstanding performance, and advanced technology, making them a perfect choice for any modern home.

The SL-750TV-IPI-D is known for its large viewing area, providing a spectacular flame presentation that is both customizable and efficient. Its advanced IntelliFire® ignition system ensures reliable and easy operation, minimizing the need for manual ignition. This model also offers a balanced flue design that allows for flexible installation options, enhancing its versatility.

Similarly, the SL-950TV-IPI-D boasts a larger firebox, providing even more impressive heat output and increased aesthetics. Its high-efficiency rating ensures that energy consumption is kept low while delivering warmth. This model also utilizes the IntelliFire system, but it is enhanced with LED accent lighting, creating an inviting atmosphere while complementing the fireplace’s flickering flames.

On the smaller end of the spectrum, the SL-550TV-IPI-D combines compact design with remarkable efficiency. Its direct vent technology offers excellent venting options, allowing installation in various locations without compromising on performance. Equipped with adjustable flame settings, homeowners can tailor the experience to their liking, creating the perfect ambiance for any occasion.

The SL-550TV-D model takes a similar approach but focuses on traditional control mechanisms. This version allows users to manage the fireplace with ease through a manual control system while still maintaining the benefits of direct vent technology.

Lastly, the SL-750TV-D version offers a grand fireplace experience. It features a stunning glass front and can serve as a stunning focal point in larger living spaces. The model's durability is paired with elegant aesthetics, ensuring clients receive not just a heating solution but also a piece of art.

Collectively, all five models prioritize efficiency, design, and user-friendly features, ensuring that Hearth and Home Technologies delivers high-performing solutions that meet varied homeowner needs while offering the flexibility of installation and styles that fit seamlessly into any environment. Whether seeking warmth, style, or both, these fireplaces are worthy investments that enhance home living.
Top Page Image Contents