Hearth and Home Technologies SL-350TRS-CE-D manual Safety and Warning Information

Page 2

SAFETY AND WARNING INFORMATION

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

!

READ and UNDERSTAND all instructions carefully before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty.

Prior to the first firing of the stove, READ the Using Your Fireplace section of the Users Guide.

DO NOT USE this appliance if any part has been under water. Immediately CALL a qualified service technician to inspect the unit and to replace any part of the control system and any gas control which has been under water.

THIS UNIT IS NOT FOR USE WITH SOLID FUEL.

Installation and repair should be PERFORMED by a qualified service person. The appliance and flue system should be INSPECTED before initial use and at least annually by a professional service person.

Always KEEP the appliance clear and free from combustible materials, petrol, and other flammable vapors and liquids.

NEVER OBSTRUCT the flow of combustion and ventilation air. Keep the front of the appliance CLEAR of all obstacles and materials for servicing and proper operations.

Due to the high temperature, the appliance should be LOCATED out of traffic areas and away from furniture and draperies. Clothing or flammable material SHOULD NOT BE PLACED on or near the appliance.

Children and adults should be ALERTED to the hazards of high surface temperature and should STAY AWAY to avoid burns or clothing ignition. Young children should be CAREFULLY SUPERVISED when they are in the same room as the appliance.

These units MUST use one of the fluing systems described in the Installing the Fireplace section of the Installers Guide. NO OTHER flue systems or components MAY BE USED.

This gas stove and flue assembly MUST be vented directly to the outside and MUST NEVER be attached to a chimney serving a separate solid fuel burning appliance. Each gas appliance MUST USE a separate flue system. Common flue systems are

PROHIBITED.

INSPECT the external terminal cap on a regular basis to make sure that no debris is interfering with the air flow.

The glass door assembly MUST be in place and sealed, and the trim door assembly MUST be in place on the stove before the unit can be placed into safe operation.

DO NOT OPERATE this appliance with the glass door removed, cracked, or broken. Replacement of the glass door should be performed by a licensed or qualified service person. DO NOT strike or slam the glass door.

The glass door assembly SHALL ONLY be replaced as a complete unit, as supplied by the gas stove manufacturer. NO SUBSTITUTE material may be used.

DO NOT USE abrasive cleaners on the glass door assembly. DO NOT ATTEMPT to clean the glass door when it is hot.

Turn off the gas before servicing this appliance. It is recommended that a qualified service technician perform an appliance check-up at the beginning of each heating season.

Any safety screen or guard removed for servicing must be replaced before operating this appliance.

This appliance is intended for use on a gas installation with a governed meter.

2

Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Installers Guide What to do if you smell gasSafety and Warning Information Table of Contents Service Parts SL-350TRS-CE-DNG, LP Service Parts List SL-350TRS-CE-DSL-350TRS-CE-D Appliance Certification Installation RegulationsApprovals and Regulations Advantica Gas Fireplace 90/396/EECGetting Started Diagram of the SL-350TRS-CE-D Recessed Depth 41.3cm Installing the FireplaceClearance Requirements Step Framing Fireplace SectionsFlue System Approvals Identifying Flue ComponentsDVP90ST SL D-Series Flue Component Specifications 102mm inner pipe/168mm outer pipeUse SL D-Series Components only Use DVP-SeriesFlue with One 90 Elbow Use DVP-Series components only Flue with Two 90 ElbowsFlue with TWO 2 90 Elbows Flue with three 90 elbows USE SL D-SERIES Components only Appliance Preparation Top FlueRear Flue Remove the insulation from the outer flue pipeInstalling Flue Components Install Support BracketsInstall Firestops Installing Support BracketsFlue Pipe & Firestop Hole and New Framing MembersFlue Termination For Horizontal Terminations using the SLK-01DA Arrow is Pointing UPTermination cap This also pertains to vertical flue systems installed Vent Termination Minimum Clearances Step Gas Control System Gas Control SystemStep Gas Supply Line Do not USE AN Open Flame to Check for GAS LeaksStep Gas Pressure Requirements Step Wiring FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Standing Pilot Ignition Wiring Diagram Step FinishingStep Installing Trim Logs, Ember Material Sealant Material Installing the TrimLOG Placement Heat & Glo SL-350TRS-CE-D 2033-900 Rev. N 10/07 Glass Assembly Placing the Ember MaterialDouble-check for faulty components Step Before Lighting Fireplace After InstallationReview safety warnings and cautions Double-check for gas leaksFireplace Maintenance Maintaining Servicing Your FireplaceBurner Flame Patterns Standing Pilot Troubleshooting Trouble- shootingCheck the thermopile with a millivolt Placed in this Opening

SL-350TRS-CE-D specifications

Hearth and Home Technologies has consistently delivered innovative and efficient heating solutions, and the SL-350TRS-CE-D is yet another remarkable addition to their lineup. This contemporary gas fireplace combines advanced technology with a sleek design, making it a popular choice for modern homes seeking both aesthetics and functionality.

One of the standout features of the SL-350TRS-CE-D is its impressive heat output. With a maximum input of 35,000 BTUs, this fireplace is capable of heating up to 1,400 square feet, ensuring cozy warmth throughout your living space. The unit employs a powerful fan system that enhances heat distribution, allowing for a comfortable environment on even the coldest days.

In terms of design, the SL-350TRS-CE-D boasts a linear configuration that creates a stunning focal point in any room. Its clean face design without visible vents allows for seamless integration into various interior styles, from minimalist to contemporary. The large glass viewing area provides an unobstructed view of the flame, inviting warmth and ambiance into your home.

The SL-350TRS-CE-D is equipped with advanced technologies that enhance its performance and user experience. It features an electronic ignition system, which ensures quick and reliable ignition, eliminating the hassle of matches or lighters. Additionally, the fireplace comes with a remote control, allowing users to easily adjust the flame height and heat output from the comfort of their seat.

Safety is also a priority with the SL-350TRS-CE-D. The unit includes a safety screen that prevents accidental contact with hot surfaces, making it an ideal choice for homes with children and pets. Moreover, the fireplace is designed with sealed combustion technology, which draws air from outside for combustion, ensuring that indoor air quality remains unaffected.

With its energy efficiency, the SL-350TRS-CE-D operates with a high efficiency rating, making it an environmentally friendly heating option. This not only helps reduce heating costs but also contributes to a sustainable lifestyle.

In conclusion, the Hearth and Home Technologies SL-350TRS-CE-D is a blend of cutting-edge technology, efficient performance, and captivating design. It is an ideal choice for those looking to enhance their living space with a modern gas fireplace that delivers comfort, safety, and style. Whether you're gathering with family or entertaining guests, the SL-350TRS-CE-D provides warmth and ambiance that will be appreciated throughout the cold months.
Top Page Image Contents