Hearth and Home Technologies SL-350TRS-CE-D Flue Pipe & Firestop, Hole and New Framing Members

Page 25

 

10" (254mm)

INTERIOR

 

WALL SHIELD

 

 

12" (305mm)

FIGURE 30.

Flue Pipe & Firestop

For Vertical Runs - One firestop is REQUIRED at the hole in each ceiling through which the flue passes.

To install firestops for vertical runs that pass through ceilings:

•Position a plumb bob directly over the center of the ver- tical flue component.

•Mark the ceiling to establish the centerpoint of the flue.

•Drill a hole or drive a nail through this center point.

•Check the floor above for any obstructions, such as wiring or plumbing runs.

•Reposition the heater and flue system, if necessary, to accommodate the ceiling joists and/or obstructions.

•Cut a 10-inch X 10-inch (254mm X 305mm) hole through the ceiling, using the firestop pipe opening as a guide.

•Frame the hole with framing lumber the same size as the ceiling joists.

10" (254mm)

10” (254mm)

 

 

CHIMNEY

 

HOLE

NEW

EXISTING CEILING

JOISTS

FRAMING

 

MEMBERS

 

CEILING

 

FIGURE 31. Hole and New Framing Members

Heat & Glo • SL-350TRS-CE-D • 2033-900 Rev. N • 10/07

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents SL-350TRS-CE-D Service PartsSL-350TRS-CE-D NG, LP Service Parts ListSL-350TRS-CE-D Approvals and Regulations Installation RegulationsAppliance Certification Advantica Gas Fireplace 90/396/EECGetting Started Diagram of the SL-350TRS-CE-D Clearance Requirements Installing the FireplaceRecessed Depth 41.3cm Sections Step Framing FireplaceIdentifying Flue Components Flue System ApprovalsDVP90ST 102mm inner pipe/168mm outer pipe SL D-Series Flue Component SpecificationsUse DVP-Series Use SL D-Series Components onlyFlue with One 90 Elbow Flue with Two 90 Elbows Use DVP-Series components onlyFlue with TWO 2 90 Elbows Flue with three 90 elbows USE SL D-SERIES Components only Top Flue Appliance Preparation Remove the insulation from the outer flue pipe Rear FlueInstall Support Brackets Installing Flue ComponentsInstalling Support Brackets Install FirestopsHole and New Framing Members Flue Pipe & FirestopFlue Termination Arrow is Pointing UP For Horizontal Terminations using the SLK-01DATermination cap This also pertains to vertical flue systems installed Vent Termination Minimum Clearances Gas Control System Step Gas Control SystemDo not USE AN Open Flame to Check for GAS Leaks Step Gas Supply LineFor Standing Pilot Ignition Wiring Appliance Requirements Step Wiring FireplaceStep Gas Pressure Requirements Step Finishing Standing Pilot Ignition Wiring DiagramSealant Material Installing the Trim Step Installing Trim Logs, Ember MaterialLOG Placement Heat & Glo SL-350TRS-CE-D 2033-900 Rev. N 10/07 Placing the Ember Material Glass AssemblyReview safety warnings and cautions Step Before Lighting Fireplace After InstallationDouble-check for faulty components Double-check for gas leaksMaintaining Servicing Your Fireplace Fireplace MaintenanceBurner Flame Patterns Trouble- shooting Standing Pilot TroubleshootingCheck the thermopile with a millivolt Placed in this Opening

SL-350TRS-CE-D specifications

Hearth and Home Technologies has consistently delivered innovative and efficient heating solutions, and the SL-350TRS-CE-D is yet another remarkable addition to their lineup. This contemporary gas fireplace combines advanced technology with a sleek design, making it a popular choice for modern homes seeking both aesthetics and functionality.

One of the standout features of the SL-350TRS-CE-D is its impressive heat output. With a maximum input of 35,000 BTUs, this fireplace is capable of heating up to 1,400 square feet, ensuring cozy warmth throughout your living space. The unit employs a powerful fan system that enhances heat distribution, allowing for a comfortable environment on even the coldest days.

In terms of design, the SL-350TRS-CE-D boasts a linear configuration that creates a stunning focal point in any room. Its clean face design without visible vents allows for seamless integration into various interior styles, from minimalist to contemporary. The large glass viewing area provides an unobstructed view of the flame, inviting warmth and ambiance into your home.

The SL-350TRS-CE-D is equipped with advanced technologies that enhance its performance and user experience. It features an electronic ignition system, which ensures quick and reliable ignition, eliminating the hassle of matches or lighters. Additionally, the fireplace comes with a remote control, allowing users to easily adjust the flame height and heat output from the comfort of their seat.

Safety is also a priority with the SL-350TRS-CE-D. The unit includes a safety screen that prevents accidental contact with hot surfaces, making it an ideal choice for homes with children and pets. Moreover, the fireplace is designed with sealed combustion technology, which draws air from outside for combustion, ensuring that indoor air quality remains unaffected.

With its energy efficiency, the SL-350TRS-CE-D operates with a high efficiency rating, making it an environmentally friendly heating option. This not only helps reduce heating costs but also contributes to a sustainable lifestyle.

In conclusion, the Hearth and Home Technologies SL-350TRS-CE-D is a blend of cutting-edge technology, efficient performance, and captivating design. It is an ideal choice for those looking to enhance their living space with a modern gas fireplace that delivers comfort, safety, and style. Whether you're gathering with family or entertaining guests, the SL-350TRS-CE-D provides warmth and ambiance that will be appreciated throughout the cold months.
Top Page Image Contents