R
2700-I WOOD INSERT (ACT)
PANEL and TRIM SET
The Outside Air Cover Boxes must be installed on both panels legs FIRST before installing the panels on the insert. See page 12.
Included in Kit: (2) side panels, left and right; (1) panel top; (2) side trim, left and right, (1) top trim (2) “L” brackets, fastener package and (2) outside air cover boxes
Tools Required: Phillips head screw driver
Panel & Trim Assembly Instructions
NOTE: You have an option of installing the trim on the panels before securing the assembly to the insert or slide trim over the panels after panels are installed.
1.Lay the panel set face down on protective covering to prevent scratching the painted surface.
2.Secure panel set together with screws provided. Figure
3.Assemble the trim pieces using the “L” brackets. Figures
13.1and 13.2.
4.Slide the trim over the panel assembly. (See Note above).
"L" Bracket |
Screw side |
panels to top |
panel |
Figure 13.1 |
View of "L" Bracket
installed
Figure 13.2
Attaching Panels and Trim to the Insert
1.Remove the insert top (if installed) by lifting up slightly then pulling towards you and set aside. See Figure 14.1 on page 14.
2.There are 2 locator pins on the top of the insert to match up with alignment holes on the back flange of the panel set. Figure 13.3
3.On the bottom of each side of the insert face is a peg.
The bottom of the panel leg will hook onto this peg.
Figure 13.3
4.Using both hands, hold the panel & trim assembly and slide it onto the locator pins and then hook the bottom of the panel legs to the pegs.
5.Place the insert top back into position. See page 14.
Slide panel over |
locator pin |
Locator pin |
Hook bottom of |
panel leg over |
peg |
Figure 13.3
September 1, 2008 | Page 13 |