TOP Installation Instructions

2700-I WOOD INSERT (ACT)

The top is packaged separately and shipped with the insert. Install on insert after unit is in place and the installation of the panels and trim are complete.

Push the top into place by aligning the pins into the slots and then press down into position.

panel Top

Top

Ashlip

Blower Motor

Figure 14.1

Blower cord may be attached on the left or right side

BLOWER INSTALLATION

Included in Kit: Blower motor and cord

Tools Needed: Phillips head screw driver

The 2700-I Insert comes standard with a blower housing already installed at the factory. All of the fasteners needed to install the optional blower are also installed on the insert. Order the optional Blower Assembly through your dealer, Part BK-7007. The blower cord can be installed on the right side or left side of the insert .

1.Remove the blower cover from the front of the unit by removing 4 screws, 2 at each end.

2.Remove the ashlip by removing the 2 screws on each side and pulling towards you. The blower housing is assembled and attached to the ashlip and will come out as one unit.

3.Remove the 4 nuts from the housing and attach the blower using the same 4 nuts. See circled area in Figure 14.2

4.Connect the white and black wires to blower motor termi- nals. Connect green ground wire to ground terminal.

5.Install strain relief onto power cord. Using a pair of pliers, squeeze strain relief and push through hole.

6.Plug in and test blower operation.

7.Re-install ashlip and blower cover.

8.Route power cord away from the unit. Do not route power cord cord under or in front of unit.

Figure 14.2

FAN SPEED CONTROL

ADJUSTMENT, IF NECESSARY*

*The fan Speed Control for this unit is adjusted at the factory, and normally does not require further adjustment.

NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.

1.With the unit plugged in, turn the Speed Control Knob to slow. (Full clockwise.)

2.Use a small screw driver to adjust the fan speed by turning the adjustment mechanism through the hole on the side of the Speed Control.

3.Adjust the speed so the fan runs slowly but does not stop. Turn clockwise to slow the fan and counter- clockwise to increase the speed.

Caution

Shock Risk.

•Do NOT remove grounding prong from plug.

•Plug directly into properly grounded 3 prong receptacle.

•Route cord away from appliance.

•Do NOT route cord under or in front of appliance.

Page 14

7007-161H

September 1, 2008