Falcon U108610-07 Fitting the Stability Bracket and Chain, Fitting a Stability Bracket, Cooker

INSTALLATION

Check the appliance is electrically safe and gas sound when you have ￿nished.

Stability bracket		Fitting the Stability Bracket and Chain
		A stability bracket and chain MUST be ￿tted when
		nn
		the cooker is connected to a ￿exible gas supply.
	Cooker	Unless properly installed, the cooker could be tipped by
		leaning on the door. Injury might result from spilled hot
		liquids or from the cooker itself.

3 mm min

Floor

ArtNo.070-0014 - Stability bracket - Wall fitting

Fig.7-6 Typical ￿oor mounting

Outer stability

bracket

Cooker

IMPORTANT: The cooker must be set to the correct height and levelled before the stability bracket is installed.

Fitting a Stability Bracket

When ￿tting a stability bracket please refer to the instructions supplied with the bracket for further details on ￿tting.

When ￿tting a stability bracket (Fig.7-6and Fig.7-7) adjust the bracket to give the smallest practicable clearance between the bracket and the engagement slot in the rear of the cooker.

Fit the bracket so that it engages as far as possible over the chassis of the cooker.

3 mm min

Fitting the Restraining Chain

	Wall	Floor	The restraining chain MUST be ￿tted.
			The length of chain between the appliance and the wall ￿xing
		Typical wall mounting	should prevent strain on the gas and electricity connections,
Fig.7-7
			but still allow access to unhook the chain when the cooker is

pull forward.

Fig.7-8	Measure the length of chain required. Use the clamp supplied
	to clamp onto the gas pipe (Fig.7-8). Fix the supplied hook
	securely to the wall.
	Restraining

chain

ArtNo.011-0007 - Restraining chain (AUS)

22