4 | Falcon U108610-07 guide

Set the Governor
Set the Governor			Fig.8-4
Unscrew the governor’s brass top. In the base of the brass top			Fig.8-4

is a plastic snap-in converter device (Fig.8-4). To convert the
governor, snap the device out of the top and ret it the other
way round. The snap-in converter device is marked to show	ArtNo.103-0006 -	cap & converter
the gas for which it is set (Fig.8-5).	ArtNo.103-0006 -	cap & converter

Make sure the device is secure in the top cap and ret the cap to the governor.

Pressure Testing

Nut	Snap-in converter device

The pressure test point is accessible on the inlet pipe at the
rear. Remove the test nipple screw and t a pressure gauge to
the test point. Turn on and light two of the hotplate burners.	Fig.8-5
	Fig.8-5

For Propane X cookers the pressure should be 2.54 kPa.

nnCheck the appliance is gas sound. nnCheck operation of all the burners.

Affix Label

Stick the appropriate gas label over the natural gas part of the appliance data label.

Page 29

Image 29

Falcon U108610-07 installation instructions 4

Contents

User Guide Installation Instructions90 Dual Fuel U108610-07 Contents WARNING The appliance and its accessible parts 1. Before You Startsurfaces To avoid overheating, DO NOT install the cooker nnDO NOT use a steam cleaner to clean the cooker Always keep combustible materials, e.g. curtains nnThis appliance is heavy so take care when moving itand ammable liquids a safe distance away from your cooker DO NOT store ammable materials in the storage Hotplate Burners 2. Cooker OverviewA B C D Fig.2-1 Fig.2-3 Fig.2-4 Wok BurnerFig.2-5 Fig.2-6 Fig.2-7 will be unstable DO NOT put it on any other burner - it is not DO NOT put it crossways - it will not t properly anddesigned to t in any of the other pan supports Fig.2-12 Always leave space around the griddle for the gases ArtNo.210-0001 Classic grill control nnNever close the grill door when the grill is onFig.2-15 Fig.2-16 A B C D E F Setting the Time of DayMinute Minder To Stop the Ovens Automatically Key Lock AUTO is Showing, But you Want to Reset to Manual CookingFig.2-30Fig.2-31 Fig.2-32 Oven Shelves - Right-hand Tall Oven Oven Shelves - Left-hand Main OvenThe Handyrack Main Oven Fig.2-35 General Oven Tips Tips on Cooking with the TimerDO NOT use the timed oven if the adjoining oven is already warm 4. Cooking Table DO NOT mix dierent cleaning products - they may 5. Cleaning Your CookerThe Single Ring Burners The Wok Burner Before you remove any of the grill parts for cleaning ‘Cook & Clean’ PanelsDO NOT use harsh abrasive cleaners or sharp metal Do not use steel wool, oven cleaning pads, or any Removing the Main Oven Linings Recommended Cleaning MethodHotplate Part Hotplate ignition or hotplate burners faulty 6. TroubleshootingWhat cleaning materials are recommended for the cooker? Never use caustic or abrasive cleaners as these will Fig.6-3 Fig.6-1 Fig.6-2Fig.6-4 An oven light is not working If you Have a Problem 7. InstallationOut of Warranty INSTALLATION Read the instructions before installing or using this appliance Installer’s Name Installer’s Company Installer’s Telephone NumberAS 5601 - ‘Gas Installations’ Failure to install the appliance correctly could Checking the Parts You will also need the following tools 2. Side Clearances - Measurements B & C 1. Overhead - Measurement A3. Side Clearances - Measurement D & E Fig.7-1 Completing the Move Lowering the Two Rear RollersOn no account try and move the cooker while it is plugged into the electricity supply Fitting the Stability Bracket and Chain Unless properly installed, the cooker could be tipped byFitting a Stability Bracket Fitting the Restraining Chain Gas Connection Pressure TestingNatural Gas Propane A N Fixed WiringFig.7-10 Fig.7-11 Grill Check Hotplate CheckOven Check Fitting the Handles and Handrail Classic only When servicing or replacing gas-carrying 8. Conversion to LP GasClassic - Removing the Control Panel Toledo - Removing the Control Panel Fig.8-4 1.1 To Remove the Control Panel 9. Servicing1.2 To Remove the Side Panels WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON 2.2 To Replace the Hotplate Control Taps 2.1 To Remove the Hotplate2.3 To Change a Hotplate Burner Injector 2.4 To Replace a Hotplate Burner Electrode 3.2 To Replace the Clock 3.1. To Replace the Ignition or Light Switch3.3 To Change the Ignition Generator 4.1 To Replace the Grill Controller 5.4 To Change an Oven Element Thermal Cut-out 5.3 To Change the Oven Element5.5 To Replace an Oven Thermostat Fig.9-4 Fig.9-5 6.6 To Adjust the Main Oven Door Catch Keep 6.3 To Adjust the Main Oven Door Angle6.1 To Remove the Grill Door 6.2 To Replace the Main Oven Door 6.8 To Replace the Tall Oven Door Outer Panel 6.7 To Remove the Tall Oven Door6.9 To Replace the Tall Oven Door Magnetic Latch 6.10 To Change an Oven Door Seal Colour 10. Circuit DiagramDescription Maximum power output @ 230V 50 Hz 11. Technical DataUsable volume litres COUNTRY OF DESTINATION AustraliaPage Page E-mail consumers@falconappliances.co.uk Clarence Street, Royal Leamington Spa Warwickshire, CV31 2AD, EnglandTel +44 0 1926 457400 Fax +44 0 1926