6.7To Remove the Tall Oven Door

6.7To Remove the Tall Oven Door

Open the oven door. Supporting the door, remove the 2 screws securing the upper hinge and packing to the cooker front. Remove the door from the lower hinge by lifting slightly and moving outwards.

Reassemble in reverse order.

6.8To Replace the Tall Oven Door Outer Panel

Remove the tall oven door (see 6.7). Lay the door face down on a suitable surface and remove the 2 screws from bottom edge of door and the 2 screws from the inside face of the door.

Remove the outer door panel. Remove the door handle by unscrewing the 2 screws.

Remove the 2 cross-headed screws holding the door handle ￿xing bracket to the door panel. Fit the door handle bracket and the door handle to the new panel.

Fit the panel to the door and reassemble in reverse order.

6.9To Replace the Tall Oven Door Magnetic Latch

Remove the control panel (see 1.1). Remove the plinth (3 screws) and the central vertical cover (5 screws). Lever the retaining clip o￿ the magnet unit.

Fit the new unit and retaining clip, and reassemble in reverse order. Check the door operation.

6.10To Change an Oven Door Seal

Open the oven door. The seal is held in place by small hooks on the rear face. At the corner, pull the seal diagonally away from the door centre until that hook is released (Fig.9-13). Proceed to the next hook and release it in a similar way, and so on. Use force if the hooks are sti￿, as the old seal will be discarded.

When ￿tting the new seal, position the seal join at the bottom. Hook the new seal in one of the corner holes of the door, and proceed round the door, snapping in each hook in turn.

Fig.9-13

ArtNo.320-0005 Oven door rubber seal

33

Page 35
Image 35
Falcon U108610-07 To Remove the Tall Oven Door, To Replace the Tall Oven Door Outer Panel, To Change an Oven Door Seal, 13