Falcon U108610-07 1 -2, 3, 4, An oven light is not working, The oven door is misaligned

Fig.6-1

Fig.6-2

ArtNo.324-0007 Unscrewing the bulb cover

Fig.6-3

E￿ect of hinge adjustment – exaggerated for clarity

Fig.6-4 Centre line of hinge pin

An oven light is not working

The bulb has probably burnt out. You can buy a replacement bulb (which is not covered under the warranty) from a good electrical shop. Ask for a 15W – 230V lamp, FOR OVENS. It must be a special bulb, heat resistant to 300 °C (Fig.6-1).

Turn o￿ the power at the circuit breaker.

Before removing the existing bulb, turn o￿ the power supply and make sure that the oven is cool. Open the oven door and remove the oven shelves.

Unscrew the bulb cover by turning counter-clockwise. It may be very sti￿ (Fig.6-2). Taking care to protect your ￿ngers with a glove in case the bulb should shatter.

Screw in the new bulb; screw back the bulb cover. Turn on the circuit breaker and check that the bulb now lights.

The oven door is misaligned

The bottom hinge of either oven door can be adjusted to alter the angle of the door (Fig.6-3). Loosen the bottom hinge ￿xing screws and use the notch and a ￿at bladed screwdriver to move the position of the hinge to set the hinge position (Fig.6-4).

Retighten the hinge screws.

ArtNo.320-0007 Oven door hinge adjustment 2

Oven door omitted for clarity

16