Grill
The grill pan and trivet should be washed in hot soapy water. Alternatively, the grill pan can be washed in a dishwasher.
After grilling meats or any foods that soil, leave to soak for a few minutes immediately after use. Stubborn particles may be removed from the trivet using a nylon brush.
Before you remove any of the grill parts for cleaning,
nn
make sure that they are cool, or use oven gloves.
nnDO NOT use any abrasive substances.
Control Panel and Doors
Avoid using any abrasive cleaners including cream cleaners. For best results, use a liquid detergent.
The control panel, knobs and doors should only be cleaned with a soft cloth wrung out in clean hot soapy water – but take care that no surplus water seeps into the appliance.
After cleaning, polish with a dry cloth.
Glass Fronted Door Panels
The oven door front panels can be taken o so that the glass panels can be cleaned. Move the cooker forward to gain access to the sides (see the ‘Moving the Cooker’ section under ‘Installation’).
Open the oven door slightly and remove the front panel xing screws from the door sides, two each side
Carefully lift o the outer door panel. The inside face of the glass panels can now be cleaned – take care not to disturb or wet the door insulation.
Note: If the door is triple glazed then the inner two panels are xed together and should not be separated.
After cleaning, carefully ret the outer door panel and replace the side xing screws.
DO NOT use harsh abrasive cleaners or sharp metal
nn
scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.
Ovens
‘Cook & Clean’ Panels
The main oven has panels which have been coated with a special enamel that partly cleans itself. This does not stop all marks on the lining, but helps to reduce the amount of manual cleaning needed.
The ‘Cook & Clean’ panels work better above 200 °C. If you do most of your cooking below this temperature, occasionally remove the panels and wipe with a lint free cloth and hot soapy water. The panels should then be dried and replaced and the oven heated at 200 °C for about one hour. This will make sure the ‘Cook & Clean’ panels are working eectively.
Do not use steel wool, oven cleaning pads, or any
nn
other materials that will scratch the surface.
Fig.5-5
Fig.5-6
13
