Falcon U108610-07 To Remove the Grill Door, To Replace the Main Oven Door, 9, 12

Fig.9-6 Fig.9-7

1		2
ArtNo.320-0001 Door hinges		ArtNo.320-0001 Door hing
Fig.9-8	Centreline of hinge pin

ArtNo.320-0007 Oven door hinge adjustment 2

Oven door omitted for clarity

Fig.9-9

6 Doors

6.1To Remove the Grill Door

Remove the left-hand side panel (see 1.2). Remove the plinth (4 screws) and the central vertical cover (5 screws). Remove the 2 countersunk screws (1 each side) securing the grill hinge arms to the front of the grill chamber.

Note: The arms are spring tensioned. Carefully remove the grill door. Retain the gaskets.

Reassemble in reverse order, making sure that the gasket is ￿tted between the hinge arm and the front of the grill chamber.

6.2To Replace the Main Oven Door

Open the oven door. Support the door and loosen the 2 screws securing the upper hinge and gasket to the cooker front (Fig.9-6).

nnThe door is heavy, so take care.

Support the door and remove the screw nearest the hinge pin (Fig.9-7). Swing the hinge up and away from the door hinge pin. Lift the door away from the lower hinge and remove.

Reassemble in reverse order.

-0006 Oven door hinge

E￿ect of hinge adjustment – exagerrated for clarity

Fig.9-10

ArtNo.320-0002a Proplus oven door side screws

6.3To Adjust the Main Oven Door Angle

The bottom hinge of the main oven door can be adjusted to alter the angle of the door (Fig.9-8). Loosen the bottom hinge ￿xing screws and use the notch and a ￿at bladed screwdriver to move the position of the hinge to set the hinge position (Fig.9-9).

Retighten the hinge screws.

6.4To Replace the Main Oven Door Outer Panel

Move the cooker forwards to gain access to the sides.

Open the main oven door slightly and remove the

4 front panel ￿xing screws from the door sides (2 each side), (Fig.9-10). Carefully lift o￿ the outer door panel.

Remove the door handle from the panel by unscrewing the 2 retaining nuts.

Fit the door handle to the new panel.

Fit the panel to the door. Reassemble in the reverse order.

		6.5 To Change the MainOven Door Latch
Fig.9-11	Fig.9-12	Remove the main outer door panel (see 6.4). Remove
	ArtNo.320-0004 Oven door keep	screws ‘B’, which hold the latch assembly to the inner
		door panel (Fig.9-11). Fit the new catch and reassemble
		in reverse order. Check the door operation.

B

ArtNo.320-0003 Oven door latch

6.6To Adjust the Main Oven Door Catch Keep

Open the main oven door, slacken o￿ the locknut at the base of the keep, and screw in or out as required until the required ￿t is obtained. Retighten the locking nut (Fig.9-12).

32