R
2700-I WOOD INSERT (ACT)
ZERO CLEARANCE ADJUSTABLE TRIM SUPPORT, 2 inch to 10 inch
Included in Kit: 1 trim top; 1 trim front; 2 trim sides;
Tools Required: Phillips head screw driver; sheet metal shears; measuring tape; gloves
CAUTION
Injury Risk.
•Gloves recommended
•May have sharp edges
EXpLODED VIEW OF SCISSORS | |
| SCREWS ARE CIRCLED |
Figure 15.1 |
|
1.The 10 screws on each set of scissors will already be loose when shipped.
2.Expand scissors to desired height. Tighten screws to hold in place using Phillips head screw driver. Figures 15.1 and 15.2.
3.Measure trim to required height to cover scissors and mark piece for cutting. Cut excess material from top of trim’s edge, not bottom. This edge will be sharp; wear gloves to prevent injury to your hands. Figure 15.2.
4.Using sheet metal shears, cut trim along the marked edge. The cut edge fits under lip of top, so it allows for some variance in your straight edge.
5.The
6.Place cut edge of trim under top lip and into position on scissors. Install the 2 side pieces first. The front piece corners will overlap the side pieces. NOTE: The trim in the Flush Mount Kit is one piece.
7.Once you are satisfied with the positioning, remove trim and set aside.
8.Remove the paper from
9.There are 3 holes in the back flange of the top to secure it to the wall if necessary. Use the appropriate fastener for the type of wall material in your installation.
NOTE: 3/8 inch (9.5mm) thick tile or like material can be cut to size and fit under lip of top trim edge for a decorative touch.
Figure 15.3.
EXPAND SCISSORS TO DESIRED HEIGH T
CUT TOP EDGE OF TRIM,
INSTALL FRONT TRIM LAST. NOT BOTTOM EDGE CORNERS OVERLAP SIDE
TRIM PIECES
Figure 15.2
Decorative tile may |
be installed |
Figure 15.3 |
September 1, 2008 | Page 15 |