LG Electronics LP121CEM-Y8 manual Cross Flow FAN, Axial FAN

2.2.2 CROSS FLOW FAN

1. Remove the front grille. (Refer to section 2.1.1)

2. Remove the control box assembly. (Refer to section 2.1.2)

3. Remove the Air-Guide Assembly from the unit. (Refer to section 2.2.1)

4. Loosen the screw on the cross flow fan. (See Figure 9)

Figure 9

5. Remove the 4 screws which fasten the indoor motor and the earth wire. (See Figure 10)

6. Remove the supports on both sides.

7. Pull the cross flow fan out from the air-guide.

8. Re-install the components by referring to the removal procedure.

Figure 10

2.2.3 AXIAL FAN

1. Remove the brace.

2. Remove the 4 screws which fasten the condenser with the shroud and the basepan. (See Figure 11)

3. Remove the condenser sideways carefully.

Figure 11

4. Remove the clamp which secures the fan with pliers.(See Figure 12)

5. Remove the axial fan.

6. Re-install the components by referring to the removal procedure.

Figure 12

Copyright ©2008 LG Electronics. Inc. All right reserved.	- 11 -
Only for training and service purposes	LGE Internal Use Only