Sears 139.53535SRT1 Instafl the Lights and the Lenses, Install the lights, Install the lenses

Page 19

6.AttachtheUserSafetyInstructionlabeltothewall

nearthedoorcontrol,andtheMaintenance Instructionlabelina prominentlocationonthe insideof thegaragedoor.

Page32explainshowto usethedoorcontrol.

Do NOT connect the power and operate the opener at this time. The trolley will travel to the full open position but will not return to the

close position until the sensor beam is connected and properly aligned.

See Safety Reversing Sensor instructions beginning on page 21.

Installation Step 7

I

Instafl the Lights and the Lenses

Install the lights:

•Install a 75 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

•If the bulbs burn out prematurely due to vibration, replace them with standard neck "Garage Door Opener" bulbs.

Install the lenses:

•Apply slight pressure on the sides of each lens and slide the tabs into the slots in the side panels.

•For convenience, the lenses may be installed after Adjustment Step 4 on page 30.

•Reverse the procedure to remove the lenses.

 

75 Watt Max

Lens

Light Bulb

Tab

 

Lens

Guide

Lens

Slot

Lens

Tab

Lens f

Tab

Installation Step 8

Attach the Emergency

Release Rope and Handle

Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.

if it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall. Use the emergency release only to disengage the trolley and, if possible, only when the door is closed.

Garage doors are heavy. If the door is open when the handle is pulled, the door could

close inadvertently if it is not properly balanced. Serious injury may result to persons under the door. Make sure the doorway is clear

of persons and obstructions before pulling handle when door is open.

Overhand

Knot

Trotle__T_olley

Rope

Release Arm

_" Emergency

_Release Handle

Overhand

Knot (:_

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A Owners UALMechanicalElectrical Start by Reviewing these Important Safety Alert SymbolsInstallation section pages 11 Installationsafety Adjustment section pages 28Youll Need Tools Center of the door. See pages 12 Cosed PositionOne=Piece Door with Track To your installationApply Carton inventory Separate AssemblyInstallation Hardware Safety Reversing Sensor InstallationAssemble the T=rail Attach the Cable Pulley Bracket Assembly Section Pages 8Hardware Shown Assembly StepInstall the Trolley on the T-rail Fasten the T-rail to the OpenerTo make sure the chain is not Install the Chain/Cable Attach the Sprocket CoverTighten the Chain & Cable To reduce the risk of severe injury or death to personsDetermine Header Bracket Location Installation Section Pages 12 Installation StepProceed to , Example Bracket to the Ceiling Fasten the HeaderAttach the T=rai! to the Header Bracket Position the Opener If the top panel hits the trolley when you raiseUnderside of the rail Hang the OpenerHardware Shown Actual Size Install the Premium Control ConsoleAttach the Emergency Install the lightsInstall the lenses Instafl the Lights and the LensesPermanent Electrical RequirementsConnections Safety reversing sensor must be connected Safety Reversing SystemActual Size Install the Safety Reversing SensorOpener Trouble ShootingFasten Door Bracket Finished Ceiling Hole Alignment Alternative Connect Door Arm to Trolley1i CevisPin 5c,g DcoUAr FigureAdjustment Procedures for One-Piece Doors Adjust the UP and Down Limits Adjustment Section Pages 28 Adjustment StepHow and When to Adjust the Limits To Adjust the Forces Adjust the ForceHow and When Test the Safety Reverse System Test The Safety Reversing SensorImportant safety check Schedule IMPORTANT Safety iNSTRUCTiONS To reduce the risk of severeMaintenance Injury or death to personsManual disconnect Operation of the DoorControls see To open the doorWith SRT Button Receiver and Remote Control Programming53000SRT Series Garage Door Openers With SRT ButtonSituation Probable Cause and Solution Having a Problem?Chain droops Situation Probable Cause SolutionOpener Garage door springs are broken. See above1418 Repair PartsRail AssemblyParts Installation PartsOpener Assembly PaNs 53885 Multi-Function Keyless EntryFor Sectional Doors Only Terminals IndexChain Tension Manual Emergency Release Rope & HandleCraftsman

139.53535SRT1 specifications

The Sears 139.53535SRT1 is an innovative garage door opener that stands out in the realm of home automation due to its robust features and advanced technologies. This model offers a blend of convenience, security, and performance, making it a popular choice for homeowners seeking efficiency and reliability.

One of the standout features of the 139.53535SRT1 is its powerful motor, designed to lift heavy garage doors with ease. With a lifting capacity suitable for both standard and heavy-duty doors, it operates smoothly and quietly, ensuring minimal disruption in residential areas. The opener also includes safety features such as the automatic reverse function, which prevents accidents by reversing the door's direction if it detects an obstruction.

This model is equipped with the latest technology to enhance user experience and security. The security+ 2.0 technology generates a new code every time the remote is used. This feature provides an additional layer of protection against unauthorized access, ensuring homeowners feel safe and secure when using their garage door opener.

In terms of connectivity, the Sears 139.53535SRT1 comes with built-in Wi-Fi capability. This allows users to control the garage door remotely via a smartphone app. Through the app, users can check the status of their garage door, open or close it from anywhere, and receive notifications about its usage. This feature is particularly beneficial for those who may forget to close the door or need to grant access to someone while away from home.

Additionally, the model includes a convenient battery backup system. This ensures that the garage door opener operates even during power outages, providing peace of mind during inclement weather or disruptions in local power supply.

Installation of the 139.53535SRT1 is user-friendly, thanks to its comprehensive guide and compatibility with most standard garage door setups. Its sleek design also adds a modern touch to any garage space, blending functionality with aesthetics.

In summary, the Sears 139.53535SRT1 garage door opener encompasses a host of innovative features like a powerful motor, advanced security technology, Wi-Fi connectivity, and battery backup. These characteristics make it a top choice for homeowners aiming for both convenience and safety in their garage door solutions.
Top Page Image Contents