Sears 139.53535SRT1 Receiver and Remote Control Programming, 53000SRT Series Garage Door Openers

Receiver and Remote Control Programming

To comply with FCC rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery THERE ARE NO OTHER USER SERVICEABLE

PARTS.

Models with 3-function remote controls: The remote controls have been factory set to operate with the large push button on the remote control. However, you can use either of the two small buttons, if you prefer. And, the 3-function remote control can also activate additional garage door openers and/or light controls.

Below are instructions for programming your opener to match the other buttons on your remote controls and any additional remote controls you may purchase. See available accessories on page 38.

53000SRT Series Garage Door Openers

(With "SRT" Button)

Your "SRT" garage door opener will operate with as many as four "SRT" portable remote controls and one Multi-Function Keyless Entry.

To Add A Remote Control

1.Press and hold the selected remote control push button, see Figure 1.

2.Then press and release the "SRT" (learn) button on the right side panel of the opener, Figure 2. The opener lights will flash once.

3.Release the remote push button.

Now the opener will operate when the remote control push button is pressed.

if you release the remote control push button before the opener lights flash, the opener will not accept the code.

To Change the Selected Push Button

On the Same Remote control

If you decide to use a different remote control button than originally programmed into the opener, you must erase aft the learned codes and reprogram each remote control used to operate the garage door opener.

To Erase All Remote control Codes

*Press and hold the "SRT" button on the opener panel until the indicator light turns off (about 6 seconds). All the codes the opener has learned will be erased.

*To reprogram, repeat Steps 1, 2 and 3 for each remote control in use.

Code programming instructions are also located on the opener panel.

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause

serious injury or death. Do not allow children to operate the door push button(s) or remote control(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Figure 1	Select	a remote	control push
	button	to operate	opener

3-Function Remote Control

Figure 2

Garage Door Opener

(With "SRT" Button)

/

"SRT" (learn) Indicator RIGHT

ButtonLight PANEL

To Add the Keyless Entry

We recommend that you program your code before you install the Keyless Entry. You will not need assistance, and you can test the reception at the mounting location before installation.

1.Choose a 4-digit code using numbers from 0 to 9. You can use a number more than once (for example, 4, 0, 4, 1). Press the selected code digits on the keypad.

2.Press and hold the Enter button while you press the "SRT" (learn) button on the opener panel. The indicator light will blink and the door will begin to move.

3.Release the Enter button. Now the opener has learned the selected keypad code.

To ensure that your portable remote control codes were not disturbed while you were programming the Keyless Entry, test your remotes and reprogram them if necessary.

To change the code at any time, repeat steps 1-3.

33