Sears 385.1915 owner manual Snap On the Presser

eCheck the Presser Foot

Your presser foot _s held m place by a		Foot Holder.	Each presser foot
merely snaps on the foot holder, which is seldom removed.
If you need to remove or attach the foot hoJder, here is what you do:
To Remove:	To	Attach:

Presser bor_

Foot

screw

o Change the Presser Foot

Use the correct presser foot for the stitch you wish to sew. Consult the Stitch Pattern Chart and the detailed directions for sewing with the various presser feet.

To snap off: To snap on:

UPiDow_

needle position

utton

Presser foot

lever burton_

To Remove:

Turn the screw toward the back of

the machine. Use the large screw driver.

To Attach:

1. Match the hote in the foot holder with the threaded hole m the presser bar.

2.Fit the foot holder screw into the hole.

3.Tighten the screw by turning It toward you.

	J	,-	_j
To Snap Off the Presser Foot:		To	Snap On the Presser

t.Press the Up/Down Needle Position Button to raise Foot:

	the needle to its highest position.	1.	Set the	Pressure ad-
2.	Raise the presser foot.		justing	]ever at "3",

3.Press the red button on the back of the foot holder, 2. Place the presser foot

The presser foot will drop off.	so	the	horizontal		pin
	on	the	foot	is	just
	under		the groove		of
	the	foot	holder.
3,	Lower		the	presser
	fool	holder		to	lock
	the	presser		foot	in
	place,

NOTE:

If you do not hear the presser foot snap in place, press down on the presser foot holder firmly until you hear the snap.

15