Only For Qualified Installers
Thermostat
INSTALLATION (Options) | 18 | ||
| Connecting the Optional Thermostat |
| |
| If the optional thermostat is used, it must be | ||
| plugged into the TH terminals located on the |
| |
| valve. |
|
|
| When installing a millivolt control system, use | ||
| only a special low resistance thermostat. DO NOT | ||
| USE A REGULAR HEATING THERMOSTAT. |
| |
| Be sure that all electrical connections are clean, | ||
| free from corrosion, and tight. Inspect connections | ||
| periodically to confirm that no corrosion has built | ||
| up over time. |
|
|
| When properly installed and maintained, a mil- | ||
| livolt control system should give many years of | ||
|
|
| |
| It is important to use wire of a gauge proper | ||
| for the length of the wire: |
| |
| RECOMMENDED WIRE GAUGES |
| |
| Maximum | Wire |
|
| Length | Gauge |
|
| 100' | 14 |
|
Burner Button | 60' | 16 |
|
40' | 18 |
| |
| 25' | 20 |
|
| 15' | 22 |
|
Remote Control Kit
The button on the remote control can be used to turn the fire on and off.
This remote uses the ultrasonic control method and does not need to be pointed directly at the fire- place.
The kit includes installation instructions, a hand held sending unit, receiving unit, mounting bracket, and all wiring.
Note: The ON/OFF switch must be “OFF” when using the remote. If the switch is in the “ON”
position, the fire will stay on even when the set tem- perature on the thermostat is reached.
Glass Grill
To install the glass grill remove the door and slide the top of the vertical bars up into the slots at the top of the firebox opening. Lower the grill down so the bottom of the vertical bars rest just inside the lip at the bottom of the firebox opening.
Reinstall door.
Glass Grill