Harman Stove Company Conquest Gas Stove Maintenance, Removing the Glass Front, Cleaning the Glass

Page 20

MAINTENANCE

A qualified service person should conduct

Gold Frame

an annual inspection and maintenance of your

 

Conquest, its venting, and the installation to

 

keep it running safely and efficiently. The fol-

 

lowing procedures should be performed only

 

by a qualified service person. The gas supply

 

should be turned off whenever a maintenance

 

procedure is performed.

 

If the glass door or side doors are removed

 

for servicing, they must be replaced prior to

 

operating the stove.

 

Latch

 

 

20

Door

Top

 

Clip

 

Glass

Bottom

Clip

Gasket

Air Grill

CAUTION: Do not operate this appliance with the glass front removed, cracked, or broken. Replacement of glass should be done by a licensed or qualified service person. Never use substitute materials.

CAUTIONNER: N’opère l’appareil avec le verre enlève, craque ou casse. Le remplacement du panneau(s) devrait être fait par une personne de service qualifiá ou autorisá.

Removing the Glass Front

Remove the air grill by pulling forward.

Lift the latch shown above and tilt the glass door out at the top and lift off the hooks at the bottom. Handle the glass with care.

DO NOT STRIKE OR SLAM GLASS

Replacing the Gasket

The Conquest uses part no. 3-44-00539 fiber- glass gasket in the front door. Should it ever need replacement, use only the proper replacement gas- ket that is available from your Harman dealer. Re- place the gasket as follows:

1.Lay glass door face down on a soft surface that will not scratch the glass.

2.Remove the nuts holding the top and bottom glass clip in place.

3.Remove glass from door and remove old gasket.

4.Install new gasket around glass.

5.Place glass back in door.

6.Reinstall glass clips and tighten the nuts.

7.Reinstall glass door by placing the slots on the bottom of the door over the hooks on the bot- tom of the door opening. Next, lift the latch and push the door against the unit. Pull the spring loaded latch front until the tab drops into the slot on the door frame.

8.Reinstall air grill.

Cleaning the Glass

The glass may be cleaned with ordinary house- hold glass cleaner and a soft cloth or paper towel.

WARNING: Never clean the glass when it is hot. Do not use abrasive cleaners on the glass.

Image 20 Contents
Safety Notice Harman Conquest Gas StoveFor Your Safety What to do if YOU Smell GAS Table of Contents Introduction4 OPERATION5 OperationOPERATION6 Pilot FlamesSPECIFICATIONS7 Ratings NaturalAlcove Clearances SpecificationsCorner Clearances Installation 8 x Description Use Only Approved VentingPart Numbers for SimpsonDura-Vent Pipe and Fittings Conquest Rear VentRequirements for Terminating the Venting Feet INSTALLATION13Damper Settings Natural Gas Kit Changing to Natural GasNatural Gas Conversion Kit INSTALLATION15 INSTALLATION16 Log PlacementEmber Placement Deflector plateInstalling Tiles Tile KitRemote Control Kit Installation OptionsConnecting the Optional Thermostat Optional Blower Maintenance Cleaning the GlassRemoving the Glass Front Replacing the GasketMAINTENANCE21 Cleaning the Log Set and FireboxCleaning the Burners Inspecting the VentingDiagram 120 Volt MAINTENANCE22Optional Blower Wiring Model Conquest WHI #Parts Glass gasket 7’/unitMAINTENANCE25 Burner PartsYes BadReplace Piezo Ignitor Turn on gas valve Replenish supply ReplaceTrouble Shooting GoodCheck inlet pressure Replace ValveBad Is Pilot litOptional Blower Label Orifice Size11 WC Input Btu/h 27,500 Converted ByDateHarman Gold Warranty Harman Gold WarrantyYear Transferable Limited Warranty Residential Year Limited Warranty Commercial