Harman Stove Company Conquest Gas Stove manual OPERATION6, Pilot Flames

Flame Height

Adjuster

Normal Flame pattern. Note: Flames will vary in height and position depending on the placement and the amount of ember wool.

15.Set the High-Low Regulator to desired setting: Turn fully counterclockwise for High and fully clockwise for Low.

NOTE: An odor, resulting from the initial heating of new materials in your heater, is not unusual during the first fire, and in most cases will disappear after an hour or two.

HOW TO TURN OFF THE FIRE

1.If using optional thermostat, set thermostat to the lowest position.

2.Turn off the electric power to the blower.

3.Turn the ON-OFF switch on the upper right rear of the stove to the OFF position.

4.Push in the gas control knob slightly and turn it clockwise to “OFF.”

NOTE: The knob cannot be turned from “PILOT” to “OFF” unless it is pushed in slightly. Do not

force it.

FLAME HEIGHT ADJUSTMENT

The flame height adjuster can be accessed by opening the right side panel. Turn the adjuster clock- wise to increase flame height and counterclockwise to decrease. See above left. Adjusting the flames too high will cause them to have black tips and cause sooting. Sooting can cause the glass to get dirty. Check flame height after five to ten minutes and re- adjust if necessary.

Pilot Flames

If pilot flames are less than shown at left, use pilot adjuster shown below, to increase flames.

Pilot Adjuster

Warning: The unit and adjuster may be hot. Wear gloves and arm protection if making adjustments while in operation.