PAGE 16 OPERATING YOUR HEATER
Before You Begin
!Read this entire manual before you use your new heater (especially the section "Safety Precautions" on pages 2 & 3). Failure to follow the instructions may result in property damage, bodily injury, or even death.
Location of Controls - See explanation below
ON/OFF |
| |
Switch | N | |
The on/off switch | ||
O | ||
| ||
is located on the |
| |
right side of the | F | |
| F | |
control cover. | O | |
| ||
|
|
The Pilot Flame can be found below the back log on the left side.
Gas
Control
Valve
ON
TO
L I
PILOT ADJ
Gas Control
Knob
VENT
HI
LO
Flame Adjust
Knob
Swing the control cover to the right to access the gas control valve, igniter, and blower control.
PILOT | OFF HI |
| |
IGNITER |
| BLOWER | |
LO | |||
| |||
Pilot Igniter | Blower Knob |
| |
Blower Knob | This knob controls the speed of the internal convection blower that pushes the |
| heated air into the room. |
On/Off Switch | This control is used to turn the heater on and off. |
Pilot Igniter | The pilot igniter is used only to start the pilot. When pressed, it sends an |
| electrical charge to the pilot assembly. This creates a blue spark directly next |
| to the pilot, igniting the pilot flame. |
Gas Control Knob | This knob is used to control gas to the heater and for starting the pilot. There |
| are three positions, ON, OFF, & PILOT. The pointer directly below the knob |
| indicates the position this knob is in. |
Flame Adjust Knob | This knob controls the flame height from low ("LO") to high ("HI"). The |
| pointer to the upper right of the knob points to the position this knob is in. |
?If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off Switch "OFF" will keep the heater off always.