Items Packed with the Heater

INSERT INSTALLATION - For qualified installers only! PAGE 9

Installation Preparation

!This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI Z223.1 and the requirements listed in this manual. Failure to follow all of the requirements may result in property damage, bodily injury, or even death.

!Notify your insurance company before hooking up this heater.

!The requirements listed below are divided into sections. All requirements must be met simultaneously. The order of installation is not rigid Ð the qualified installer should follow the procedure best suited for the installation.

¥Propane Conversion Kit

¥Owner's Manual

¥Log Set (2 Logs, 2 Twigs, Embers)

¥Gas Inlet (3/8" Pipe)

¥2 Leveling Bolts (3/8"-16 x 3" Carriage Bolts - used to level the heater in fireplaces with stepped-up hearths)

Order of Installation

1If the heater is to use propane, install the propane conversion kit (see page 31)

2 Connect the gas inlet (see page 12)

3 Re-route the power cord (if desired - see below)

4 Position the heater (see "Heater Placement")

5 Connect the gas line. Connect the gas vent.

6 Follow the instructions under "Finalizing the Installation" on pages 14 and 15. 7 Install the surround panel kit.

Re-Routing the Power Cord to the Front

The power cord may be re-routed to the front of the heater if desired (see the directions below).

1Disconnect the strain relief at the rear of the heater.

TO REMOVE THE STRAIN RELIEF

Compress the strain relief from the top and bottom with a pair of slip joint pliers. Once compressed, the strain relief can be pulled out.

TO INSTALL THE

STRAIN RELIEF

Compress the strain relief from the top and bottom and insert it into the hole until it locks in place.

Strain Relief

Power Cord