Avalon Stoves 700 B-VENT manual Installation Preparation, Items Required for Installation

PAGE 6 STOVE INSTALLATION - For qualified installers only!

Installation Preparation

!This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI Z223.1 and the requirements listed in this manual. Failure to follow all of the requirements may result in property damage, bodily injury, or even death.

!Notify your insurance company before hooking up this heater.

!The requirements listed below are divided into sections. All requirements must be met simultaneously. The order of installation is not rigid Ð the qualified installer should follow the procedure best suited for the installation.

Items Required for Installation

¥B-Vent System

¥Brass, Black, or Cast Legs or Pedestal

¥Gas Hookup Equipment

Items Packed with the Chelan (700) B-Vent

¥Gas Inlet (3/8" Pipe)

¥Propane Conversion Kit

¥Owner's Manual

¥Log Set (2 Logs, 2 Twigs, Embers)

¥2 Leveling Bolts (3/8"-16 x 3" Carriage Bolts - not used for stove installations)

Order of Installation

1Attach the legs or pedestal (see page 26)

2If the heater is to use propane, install the propane conversion kit (see page 31)

3 Position the heater, use floor protection if needed

4 Attach any optional equipment.

5 Connect the gas line. Connect the gas vent.

6 Follow the instructions under "Finalizing the Installation" on pages 14 and 15.

Stove Clearances

Straight Installations Corner Installations

When installed with this clearance, the vent is 6-1/4" from the back wall, 19-1/2" from the side wall.

10" Min.

4" Min.

When installed with this clearance, the vent is 13-1/2" from the wall.

4" Min.

45¡